无刷直流电机用霍尔传感器定位方法  

Located Method of Hall Sensor for BLDCM

作　　者：刘吉超[1,2] 李巴津[1] 伍春生 

机构地区：[1]内蒙古工业大学电力学院,内蒙古呼和浩特010000 [2]江苏浩峰汽车附件有限公司,江苏常州213000

出　　处：《微电机》2014年第7期59-62,共4页Micromotors

摘　　要：霍尔传感器的安装位置直接决定无刷直流电机的工作效率,影响电机换相脉动;提出三种通用的霍尔传感器定位法:短时脉冲定位法、磁势计算法、相角补偿法。利用PWM控制方式分别对三种方法进行了验证,试验数据表明,三种方法均可以实现电机的正常换相,换相脉动小,安装误差非常小;可供工程技术人员参考借鉴。The working efficiency and effect of commutation ripple of BLDCM are directly determined by the installation position of hall sensor. This paper presented three general methods of hall sensor positioning method： short pulse positioning method,magnetic potential calculation method and phase compensation method. Via PWM control methods to validate these methods,and the experimental data show that three methods can achieve normal commutation,low commutation ripple and low installation errors. The engineering and technical personnel can refer to three methods.

关 键 词：无刷直流电机 短时脉冲 磁势计算 相角补偿 

分 类 号：TM33[电气工程—电机]