微细电火花内冲液小孔加工的非电参数工艺研究  

Study on Non-electric Parameters of Inner Jetted Dielectric Small Holes in Micro-EDM

作　　者：王振龙[1] 张静[1] 王玉魁[1] 耿雪松[1] 

机构地区：[1]哈尔滨工业大学机电工程学院,黑龙江哈尔滨150001

出　　处：《电加工与模具》2014年第4期1-3,7,共4页Electromachining & Mould

基　　金：国家自然科学基金资助项目(51275112);国家科技重大专项(2012ZX04001-011);国家重点基础研究发展计划(973计划)课题(2012CB934102)

摘　　要：采用内冲液方式能有效提高微细电火花小孔加工的效率,研究了微细电火花内冲液孔加工中的内冲液压力、电极转速等非电参数对加工效率和电极损耗的影响及电极转速对孔径大小的影响。通过实验发现,当内冲液压力达到一定值后,其对效率的提高作用会减弱;高转速电极对提高加工效率、降低电极损耗很有必要;且电极转速越高,放电越均匀,加工出的孔径越小。The way of inner jetted dielectric can greatly improve the efficiency of small holes in micro-EDM. The effect of the non-electric parameters,such as the pressure of the inner jetted dielectric and the turning speed of electrode,on efficiency and electrode wear rate （EWR） of micro- EDM small holes machining was studied,and the effect of turning speed of electrode on the size of holes is analyzed. It was found that the improving effect of the pressure will be weakening when the pressure reached a certain value. The electrode with high speed is very necessary on improving the efficiency and reducing the EWR,and the higher speed of the electrode with,the more evenly the discharging will be, and the smaller the size of the machined holes will be.

关 键 词：微细电火花加工 小孔加工 内冲液压力 电极转速 

分 类 号：TG661[金属学及工艺—金属切削加工及机床]