太湖淤泥和自来水厂污泥混合制砖研究  

Research of Brick Making by Mixture of Sludge from Taihu Lake and Waterworks

作　　者：耿飞[1] 潘龙[2] 解建光[1] 王永君[2] 陈泽昊[1] 李浩然[1] 刘晓军[1] 

机构地区：[1]南京航空航天大学航空宇航学院,江苏南京210016 [2]江苏龙腾工程设计有限公司,江苏南京210007

出　　处：《环境保护科学》2014年第4期70-74,共5页Environmental Protection Science

基　　金：江苏省太湖治理科研项目(TH2012206)基金资助

摘　　要：以太湖淤泥和自来水厂污泥为原料进行烧结砖的制备研究,干原料经混合加湿搅拌,制成4 cm×4cm×4cm的砖体试样,干燥后放入马弗炉中焙烧;测试了砖坯的含水率、干燥收缩,烧结砖的烧失量、烧成收缩、表观密度、吸水率和抗压强度,并利用XRD和SEM分别测试了烧结砖的矿物成分,和微观形貌特征。研究结果表明,减少淤泥含量导致砖的密度和抗压强度降低,烧失量、烧成收缩率和吸水率上升;淤泥掺量减少到60%,成型含水率为23%,经950℃高温煅烧后,所得砖体质量较好,强度满足MU10等级。In this research,sludge from Taihu Lake and waterworks were used as the raw materials to produce sintered bricks.The raw materials were first mixed,humidified and agitated.Then,they were casted to brick samples in 4 cm × 4 cm × 4 cm and sintered in a muffle furnace after drying treatment.Properties of the bricks were determined including moisture content,drying shrinkage,loss on ignition,firing shrinkage,apparent density,water absorption rate and compression strength.Mineral composition of the bricks was tested by XRD and microscopic morphology features of the bricks were analyzed by SEM.The results showed that reduction of sludge content resulted in a decrease of the density and compression strength but an increase of the loss on ignition,firing shrinkage and water adsorption rate.When sludge content was reduced to 60％,the moisture content of the mold bricks was 23％.After calcination at 950℃,quality of the finished bricks was good and the strength accorded with the requirements of load-bearing walls （MU10） of the Chinese national standards.

关 键 词：太湖淤泥 污泥 烧结砖 性能 

分 类 号：X705[环境科学与工程—环境工程]