卷烟条盒输送线堵塞报警装置设计及应用  

Design and application of cigarette conveying line clogging alarm device

作　　者：王淑英[1,2] 黄玉彦[2] 乔茜华 王永华[2] 

机构地区：[1]河南中烟工业有限责任公司新郑卷烟厂,河南郑州451150 [2]郑州轻工业学院电气信息工程学院,河南郑州450002

出　　处：《郑州轻工业学院学报（自然科学版）》2014年第4期43-45,60,共4页Journal of Zhengzhou University of Light Industry:Natural Science

摘　　要：为减少卷烟条盒输送线因堵塞造成的残次品数量和堵塞停机时间,设计了卷烟条盒输送线堵塞报警控制装置.在动力头区域安装堵塞检测装置,通过PLC和变频器切换接口,并安装LED大屏幕,来实现快速定位报警设置,当堵塞发生时可及时报警,并准确指示堵塞点.采用该装置后,每次堵塞发生时的残品烟数量由原来的平均300条降低到10条以下,排除故障平均时间由原来的30 min缩短到5 min以内,提高了工作效率,降低了产品残次率.To reduce the number of defective products and the downtime caused by the blockage of cigarette conveying line,the alarm control unit was designed to solve blockage of cigarette conveying line. The jam detection device in power head area was installed. By PLC and inverter switch interface,and installation of LED large screen,rapid locating alarm position was achieved. It would alarm timely and indicate jam accurately when congestion occured. The quantity of defective tobacco products could be controlled under ten compared to the previous situation when each congestion occured and the average time of troubleshooting was shortened from thirty minutes to less than five minutes after the device was adopted. The device could improve work efficiency and reduce the rate of defective products.

关 键 词：卷烟条盒输送线 堵塞检测器 定位报警显示 

分 类 号：TS411.1[农业科学—烟草工业]