基于Simulink的直接序列扩频通信系统仿真设计  

Design of direct sequence spread spectrum communication system based on Simulink

作　　者：马小青[1] 

机构地区：[1]西安欧亚学院信息工程学院,陕西西安710065

出　　处：《现代电子技术》2014年第22期34-37,共4页Modern Electronics Technique

基　　金：教育创新基金项目(120107);西安欧亚学院核心课程建设项目(131220)

摘　　要：以Matlab提供的可视化仿真工具Simulink搭建直接序列扩频通系统仿真模型,利用Simulink对直接序列扩频通系统的发射机模块和接收机模块进行仿真设计,通过传输过程中各个波形和频谱变换图,研究直扩系统误码率、信噪比和扩频增益的关系。在给定的仿真条件下,运行测试仿真模型,结果表明,该系统信噪比较高,性能较好,且在误码率保持不变的情况下,增加直扩通信系统的扩频增益可以增加输出端的信噪比。The visual simulation tool Simulink provided by Matlab is used to build a simulation model of direct sequence spread spectrum communication system. The simulation design of transmitter module and receiver module of direct sequence spread spectrum communication system was carried out with Simulink. The relationship among BER,SNR and spreading gain of DSSS system was researched by means of every waveform and spectrum transformation diagram in the transmission process. The simulation model was tested under the given simulation conditions. The results show that the system has high SNR,good perfor-mance and constant bit error rate;and the signal-to-noise ratio at the output end can be improved if the spread gain of the direct sequence spread spectrum communication systems is increased.

关 键 词：直接序列扩频 信噪比 扩频增益 

分 类 号：TN911-34[电子电信—通信与信息系统]