超高功率电弧炉变压器的设计  被引量:1

Design of Transformer for Ultra-High-Power Electric Arc Furnace

在线阅读下载全文

作  者:侯栋[1] 姜周华[1] 龚伟[1] 殷志祥 

机构地区:[1]东北大学材料与冶金学院,辽宁沈阳110819 [2]达力普石油专用管有限公司,河北沧州061000

出  处:《东北大学学报(自然科学版)》2014年第12期1722-1726,共5页Journal of Northeastern University(Natural Science)

基  金:国家自然科学基金资助项目(51174050;51274266);国家高技术研究发展计划项目(2012AA03A503;2012AA03A504)

摘  要:提出了一种新的高阻抗电弧炉变压器二次电压和最大额定电流的设计方法.熔末升温期"甩抗"后,为保证电效率最大,即电弧电压始终处在泡沫渣下的峰值,且充分发挥变压器能力,就必须对分档电压和最大额定电流进行合理的设计."甩抗"后,根据泡沫渣最大高度、功率因数、变压器额定容量等约束条件,建立了变压器分档电压和最大额定电流的设计原则,使变压器利用率和电弧功率达到最大,缩短冶炼周期.同时提出了变压器容量和最高、最低二次电压的设计方案.对80 t高阻抗电弧炉设计参数和理论运行参数进行分析,结果表明:分档电压设计在734 V为最佳,超过734 V时,变压器的最大额定电流成为提高电弧功率的限制性环节.A new design method for high-impedance electric arc furnace transformer voltages and rated current is put forward. After the "reactor short-circuit", in order to ensure electrical efficiency by maintaining the arc voltage at the peak value in foaming slag, and to make full use of the transformer capacity, the stepped voltage and rated current of the transformer should be properly designed. The design principle for stepped voltage and rated current is established considering the constraint conditions of foaming slag thickness, power factor and transformer capacity, which will increase the transformer utilization and arc power, and cut down the melting time. At the same time, the designs of the maximum and minimum secondary voltages and transformer capacity are introduced. The results of analyzing the theoretical operation and design parameters of a 80 t high-impedance arc furnace show that the optimum stepped voltage is 734 V. Above 734 V, the limiting factor of increasing arc power is the rated current.

关 键 词:高阻抗电弧炉 变压器容量 变压器额定电流 变压器二次电压 甩抗 

分 类 号:TM924.4[电气工程—电力电子与电力传动]

 

参考文献:

正在载入数据...

 

二级参考文献:

正在载入数据...

 

耦合文献:

正在载入数据...

 

引证文献:

正在载入数据...

 

二级引证文献:

正在载入数据...

 

同被引文献:

正在载入数据...

 

相关期刊文献:

正在载入数据...

相关的主题
相关的作者对象
相关的机构对象