检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:刘泽田[1,2] 陆斌[2] 惠鑫[2] 董瑞峰[3] 麻永林[1]
机构地区:[1]内蒙古科技大学材料与冶金学院,内蒙古包头014010 [2]内蒙古包钢钢联股份有限公司薄板坯连铸连轧厂,内蒙古包头014010 [3]内蒙古工业大学材料科学与工程学院,内蒙古呼和浩特010051
出 处:《山东冶金》2014年第6期34-35,38,共3页Shandong Metallurgy
摘 要:设计了采用厚规格连铸坯生产薄规格船板的工艺技术,并分析了两种不同轧制工艺下生产的薄规格EH40的力学性能和显微组织的差异。结果表明,自开坯工艺会显著影响到钢板的低温冲击韧性和微观组织。不合适的自开坯工艺使钢板混晶严重,并产生较多尺寸较大的异常晶粒,对钢板的低温冲击韧性不利。而采用大压下量、少道次数完成自开坯,会减轻钢板的混晶程度,消除尺寸较大的异常晶粒,显著提升钢板的低温冲击韧性。In this article, rolling process that how to make thin plates using thick casting slabs was designed. The difference of mechanical property and microstructure of EH40 with two different rolling processes were also researched. The results showed that the self-cogging process had obvious influences on the low temperature toughness and microstructure of plates. An unreasonable self-cogging process can cause terrible mixed crystal and some bigger grains, which have bad effects on the low temperature toughness. If less passes were used in self-cogging process by applying bigger draft every pass, good microstructure was gained. The grain was uniform and small, and plates have excellent low temperature toughness.
分 类 号:TG335.51[金属学及工艺—金属压力加工] TG135.1[一般工业技术—材料科学与工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.200