水稻秸秆压块热值模型构建及其影响因子相关性分析  

Establishment of predicted model of calorific value for rice straw briquetting and analysis of correlation of its influencing factors

作　　者：陈树人[1] 蒋成宠 姚勇 蒋晓霞[1] 

机构地区：[1]江苏大学现代农业装备与技术教育部重点实验室,镇江212013 [2]江苏圆通农机科技有限公司,镇江212325

出　　处：《农业工程学报》2014年第24期200-208,共9页Transactions of the Chinese Society of Agricultural Engineering

基　　金：国家农业科技成果转化资金资助项目(2013GB2C100182);江苏省农业科技支撑计划资助项目(BE2013412);江苏高校优势学科建设工程资助项目(苏政办发(2014)37号)

摘　　要：为建立水稻秸秆压块热值预测模型和高品质燃料压块挤压成型提供理论依据,该文以9JYK-2000A型环模式成型机生产的水稻秸秆压块作为试验样本,并以密度、含水率、挥发分为影响因素,以压块的低位热值和高位热值为试验指标进行试验研究。试验采用三因素五水平二次回归正交旋转中心组合设计试验方法,利用Design-Expert8.0.6软件回归分析法和响应面分析法,建立了3个因素对热值影响的数学模型,对所建立的数学模型进行了试验性验证,其误差范围小于5%。试验分析表明:各因素对低位热值的影响顺序依次是:密度>含水率>挥发分,对高位热值的影响顺序依次是:密度>挥发分>含水率;密度是1.39 g/cm3,含水率为13.68%,挥发份为0.76,可达最佳低位热值2 849.45 kcal;最佳高位热值的模型指标为:密度为0.92 g/cm3,含水率为23.21%,挥发分为0.75,可达最佳高位热值4 313.54 kcal。最佳综合热值模型的指标为:密度为1.18 g/cm3,含水率为11.78%,挥发分为0.78,水稻秸秆压块的低位热值为2 830.48 kcal,高位热值为4 488.05 kcal;密度为1.43 g/cm3,含水率为14.84%,挥发分为0.80,水稻秸秆压块的低位热值为2 851.08 kcal,高位热值为4 480.91 kcal。China is a large agricultural nation with abundant straw, and the straw is regarded as a kind of precious biology resource. However, the resource of straw is seriously burned, or not utilized, which causes severe pollution to the environment. Thus, in order to make full use of the straw, a technique and machine used for the extrusion and molding is needed. By the extrusion of a molding machine, the straw can be compressed into briquetting with higher density and calorific value, and can be used as one type of effective fuel in an oven. So as to mold the briquetting with superior combustion characteristic, relevant research about the calorific value of rice straw briquetting was conducted. For the establishment of the predicted model of the calorific value of the rice straw briquetting and in order to provide a theoretical basis for the extrusion molding of the high quality fuel briquetting, the rice straw briquettings were used as the research object and the test samples, produced from a ring molding machine of the type of 9JYK-2000 A, and the density, moisture content, and fugitive constituent were taken as the influencing factors. The low calorific value and the high calorific value of briquetting were used as the test index in the experimental study. Before the experiment, various physical properties demanded of rice straw briquettings were prepared with the aid of the experimental apparatus, such as the grinder, dryer, muffle, and so on, and then the briquettings were classified and bagged. The experiment was designed as a quadratic regression orthogonal of three factors and five levels, and by using the regression analysis method and response surface analysis of the software of Design-Expert 8.0.6, the mathematical model concerning the three factors＇ impact on the calorific value was set up and analyzed, and the experimental verification of the mathematical model was also conducted. Compared with the experimental result, it turned out that the range of error was less than 5%, which meant that the model est

关 键 词：秸秆 模型 热值 压块 相关性 

分 类 号：TK6[动力工程及工程热物理—生物能] S261.1[农业科学—农业水土工程]