瓦斯抽采钻孔受限空间内钻屑运移特征  

Transportation characteristics of drilling cuttings in gas drainage borehole

作　　者：王永龙[1] 孙玉宁[1] 王振锋[1] 宋维宾[1] 

机构地区：[1]河南理工大学能源科学与工程学院,焦作454000

出　　处：《科技导报》2015年第1期47-51,共5页Science & Technology Review

基　　金：国家科技支撑计划项目(2013BAA03B02);河南理工大学博士基金项目(B2014-053)

摘　　要：应用气力输送理论,建立钻屑颗粒群孔内悬浮模型,推导钻屑颗粒群启动最小气流速度求解方程,结合案例分析钻屑颗粒直径、摩擦系数及钻孔倾角对钻屑颗粒群启动速度的影响规律。结果表明,施工俯孔时,最小启动风速存在极值θD,θD<θ<0时,伴随钻孔倾角θ绝对值增大,所需最小启动风速va逐渐增大,在θD^-π/2范围,伴随钻孔倾角绝对值的增大,所需最小启动风速va呈现小幅度减小趋势;施工仰孔时,存在角度θU,当0<θ<θU时,伴随仰孔倾角逐渐增大,所需最小启动风速逐渐降低,当θ>θU时,钻屑在自重作用下自行滑落;摩擦系数对最小启动风速的影响规律与钻孔倾角类似,当俯孔倾角θ=-π/2时,不同摩擦系数曲线交于同一点,表明当θ=-π/2时,最小启动风速与摩擦系数无关。Based on pneumatic conveying theory,the suspension model of drilling cuttings has been established,the minimal startup speed of the drilling cuttings was derived,and the influence of diameter of drilling cuttings,friction coefficient,and drilling angle on the start-up speed was analyzed. The results show that in downward drilling engineering,there existed a drilling angle θDwhen the start-up speed reached its maximum value. When the drilling angle was in the range of θD^0,the start-up speed vaincreased with increase of the absolute value of the drilling angle; when the drilling angle was in the range of θD^-π/2,vadecreased slightly with increase of the absolute value of the drilling angle. In upward drilling engineering,there existed a drilling angle θU. When the drilling angle was in the range of 0~θU,the start-up speed vadecreased gradually with increase of the drilling angle; when the drilling angleθ〉θU,the drilling cuttings will slide under gravity. Similar influence of the friction coefficient on the minimal start-up speed was obtained. When the drilling angle θ=-π/2,different curves met in one point,indicating that the start-up speed had nothing to do with the friction coefficient.

关 键 词：瓦斯抽采 钻屑 最小启动风速 钻孔倾角 

分 类 号：TD712.6[矿业工程—矿井通风与安全]