检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:朱红光[1] 易成[1] 姜耀东[1] 谢和平[2] 杨鸣泽
机构地区:[1]中国矿业大学煤炭资源与安全开采国家重点实验室,北京100083 [2]四川大学,四川成都610065
出 处:《中国矿业大学学报》2015年第1期24-28,共5页Journal of China University of Mining & Technology
基 金:国家重点基础研究发展计划(973)项目(2010CB226801;2010CB732002;2011CB201201)
摘 要:基于立方定律推导了交叉联接方式的流量计算方法,讨论得出了该方法与实测结果存在偏差的主因:过量压力降损耗.定义了过量压力降损耗系数,分析了过量压力降损耗系数的变化规律.结果表明:影响交叉裂隙的过量压力降损耗的因素有:交叉角度、裂隙隙宽及雷诺数,其中雷诺数对过量压力降损耗的影响最大;过量压力降损耗系数与雷诺数近似成二次下降的关系;交叉裂隙中流体的偏流及交汇只是表象,裂隙交叉处的流动收缩或者扩张效应才是过量压力降损耗产生的真正机制.在此基础上得到了交叉裂隙的准确流量计算公式,并探讨了该公式在实际裂隙网络中的简化应用方法.By using Cubic law,the flow calculation method of cross connection is deduced.Excess pressure loss is found out to be the principal cause of its deviation from the measured result.Excess pressure loss coefficient is defined;the change of excess pressure loss coefficient is analyzed.Results show that the factors effecting excess pressure loss of cross fractures are cross angle,fracture aperture and Reynolds number,among which the Reynolds number has the largest impact.The excess pressure loss coefficient decreases squarely with Reynolds number.Flow contraction and expansion in cross fractures,rather than bias flow and intersection,turns out to be the real mechanism that causes excess pressure loss.Accordingly,an accurate flow formula for cross fracture is build,and its application with simplified method for actual fracture network is discussed.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.90