内啮合齿轮副加工误差状态下的强度分析  

Strength Analysis of Inner Gear Pair with Machining Error

作　　者：韩雪[1,2] 田杨 黄恺[3] 

机构地区：[1]辽宁工程职业学院,辽宁铁岭112008 [2]铁岭技师学院,辽宁铁岭112008 [3]辽宁工业大学,辽宁锦州121001

出　　处：《新技术新工艺》2015年第2期115-117,共3页New Technology & New Process

摘　　要：以内啮合齿轮副为研究对象,以Pro/E软件参数化建模为基础,建立了理想内啮合齿轮模型和误差内啮合齿轮模型,在ANSYS软件中分别对理想模型和误差模型进行了齿轮接触强度分析。通过对比分析表明,加入误差后,无论是哪种啮合齿轮,最大应力发生的部位和大小均有所变化。In the paper, toke the straight tooth meshing spur gear as the research object and based on Pro/E software parametric modeling, ideal internal gear model and error model of the internal gear in ANSYS software was established re- spectively for gear contact strength analysis. Comparative analysis between ideal state and error state was presented and the conclusion was obtained. The analysis results showed that the maximum stress value and its location vary no matter what kind of mesh gear is concerned or not.

关 键 词：内啮合齿轮副 误差模型 PRO/E 有限元 

分 类 号：TH132.417[机械工程—机械制造及自动化]