基于ABAQUS的定切削用量下硬脆材料切削力与材料属性关系研究  

Research on the Relationship of Hard Brittle Material between Cutting Force and Material Property under Certain Cutting Quantify based on ABAQUS

作　　者：李琛[1] 曹小兵[1] 姚学练 胡涛[1] 马廉洁[1] 

机构地区：[1]东北大学秦皇岛分校控制工程学院,河北秦皇岛066004

出　　处：《新技术新工艺》2014年第9期72-74,共3页New Technology & New Process

基　　金：国家自然科学基金资助项目(51275083)

摘　　要：设计了单因素仿真试验,利用ABAQUS有限元软件对切削力与材料属性的关系进行了仿真,并对仿真结果进行了分析。基于最小二乘原理对定切削用量下切削力与3种材料属性的关系进行了数值拟合,并用R-square对拟合结果进行了检验,分析表明拟合结果具有一定的可靠性。随着弹性模量的增加,切削力有明显增大的趋势,当泊松比≤0.3时,切削力约35N;当泊松比>0.3时,切削力呈现出迅速上升的趋势。切削力随密度的增加总体呈现下降的趋势。The simulation of single factor experiment was designed,the relationship between the cutting force and material properties was simulated by ABAQUS software,and the simulation results were analyzed.Based on the principle of the least squares,the relationship between cutting force and 3kinds of materials properties was studied by numerical fitting under the constant cutting parameter,the fitting results was inspected by the＂R-square＂.The results showed that the fitting results had certain reliability.With the increase of elasticity modulus,the cutting force has an obvious tendency of increase,when poisson＇s ratio is less than 0.3,the cutting force is in the vicinity of 35 N.When poisson＇s ratio is more than 0.3,the cutting force presents a rapidly rising trend,and it presents an overall declining trend with the increase of density.

关 键 词：切削力 材料属性 ABAQUS 硬脆材料 

分 类 号：TH161[机械工程—机械制造及自动化]