检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:程明胜 颜玢玢[1] 桑新柱[1] 王葵如[1] 苑金辉[1] 余重秀[1] 罗艳华[2] 彭纲定[2] 贾昌鑫
机构地区:[1]北京邮电大学信息光子学与光通信国家重点实验室,北京100876 [2]澳大利亚新南威尔士大学电气工程与通信学院光子学与光通信实验室
出 处:《中国激光》2015年第4期117-123,共7页Chinese Journal of Lasers
基 金:国家自然科学基金青年科学基金项目(61405014)
摘 要:基于自主研制的掺铋光纤,对其进行光谱特性的实验和理论研究。通过实验测得的吸收光谱发现了4个明显的吸收带,其中心分别是494、816、946、1410 nm。运用Giles模型对此光纤进行了放大特性的研究,分析了光纤长度、抽运功率和输入信号光功率等参数对信号的增益和噪声指数的影响。建立了稳态情况下三能级跃迁模型的速率方程和传输方程,并利用Runge-Kutta算法进行了数值研究。结果表明掺铋光纤在波长为830 nm、功率为200 m W的光波抽运时,1384~1480 nm波段的增益系数大于1.5 d B/m,噪声系数趋近5 d B。Spectral properties of bismuth- doped optical fiber developed independently are experimentally and theoretically studied. The four absorption peaks centered at 494, 816, 946 and 1410 nm are observed in the absorption spectrum of the fiber. Using the Giles model, the amplification characteristics of the fiber are studied, and the influences of fiber length, pump power and input signal power on the gain and noise figure are analyzed. In the steady state, the rate equations and propagation equations of three-level model are established and calculated by means of Runge-Kutta method. The results show that when the bismuth-doped optical fiber is pumped at 830 nm and 200 mW in power, gain coefficients between from 1384 nm to1480 nm are large than 1.5 dB/m and the noise figures are nearly 5 dB.
关 键 词:光纤光学 光谱学 掺铋光纤 GILES模型 吸收谱 增益系数
分 类 号:TN929.11[电子电信—通信与信息系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.223.213.54