基于HNC-210B华中数控系统的雕铣机床控制  

Engraving and Milling Machine Control Based on HNC-210B Huazhong NC System

作　　者：罗敏[1] 刘凌云[1] 陈凌云[1] 陈志楚[1] 

机构地区：[1]湖北汽车工业学院电气工程系,湖北十堰442002

出　　处：《机床与液压》2015年第8期118-121,127,共5页Machine Tool & Hydraulics

基　　金：国家科技支撑计划资助项目(2012BAF13B10)

摘　　要：针对EM5060雕铣机床的控制要求,提出基于华中数控系统的控制方案。硬件以HNC-210B华中数控装置为基础,软件以HNC-08M华中数控系统为基础,并利用脉冲串控制方式实现与SANYO交流伺服驱动的连接与匹配,完成了3个基本伺服轴的半闭环控制。利用10 V模拟接口控制VFD-M台达变频器,驱动电主轴。机床输入输出全部使用远程I/O。实际运行证明机床的数控改造成功。In order to meet the requirements on EM5060 engraving and milling machine, the control scheme based on Huazhong NC system was put forward. Its hardware was based on HNC-210B numerical control unit, its software was based on HNC-08M numeri-cal control system. The pulse string control mode was applied for the feed servo drive. The incremental position encoders were equipped for semi close-loop control. Electric spindle was driven by VFD-M DELTA inverter which was controlled through 10V analog interface. The remote I/O was applied for the machine. The practical application shows that the CNC rebuilding is successful.

关 键 词：数控 雕铣机 伺服驱动 

分 类 号：TP23[自动化与计算机技术—检测技术与自动化装置]