轻量化阶梯孔结构电解加工试验研究  

Experimental Research on Electrochemical Machining of Lightweight Stepped Hole Structure

作　　者：刘玉杰[1] 赵建社[1] 干为民[2] 祈璐 

机构地区：[1]南京航空航天大学,南京210016 [2]常州工学院,常州213002

出　　处：《中国机械工程》2015年第11期1429-1433,1515,共6页China Mechanical Engineering

基　　金："十二五"总装预研项目(51318030403);江苏省数字化电化学加工重点建设实验室(常州工学院)开放基金资助项目(KFJJ2004002)

摘　　要：针对内大外小轻量化阶梯孔结构特点与加工难点,采用固定阴极电解加工方式实现其内孔加工。以某飞机起落架转轴中心阶梯孔为例,为提高其加工质量及加工效率,基于数值分析和试验验证的方法优化了阴极结构,结合实际生产需要,提出了阶梯式变电压加工方法。在上述基础上修正阴极锥度并进行工艺试验,最终加工出合格件,该方法加工质量稳定,满足批量生产需要。For the structure characteristics and machining difficulties of lightweight stepped hole with big inside and small outside,a fixed cathode electrochemical machining method was proposed to realize the inner hole machining.Taking the center stepped hole on rotation shaft of an airplane land-ing gear for example,in order to improve the machining quality and efficiency,the cathode structure was optimized firstly based on numerical analysis and experimental verification.Stepped variable volt-age machining method was proposed which met the actual production needs.Based on the above,ta-per of cathode was modified and experiments were conducted.Finally,passable products were manu-factured and the process is stable,which can meet the requirements of mass process.

关 键 词：阶梯孔 电解加工 固定阴极 数值分析 阶梯式电压 

分 类 号：TG662[金属学及工艺—金属切削加工及机床]