一种简易铸造纪念鼎的工艺方法  

A Simple Method for Casting Commemorative Tripod

作　　者：令军科 袁宏彦 

机构地区：[1]陕西金鼎铸造有限公司,陕西宝鸡722408

出　　处：《铸造工程》2015年第4期52-54,共3页Foundry Engineering

摘　　要：介绍一种铸造大型纪念鼎的方法一一刮板造型工艺。列举了刮板造型的顺序，并进行实际的铸造生产，成功铸造出材质为QT450—10，高度1960mm，直径1530mm的大型纪念鼎。实践说明，采用刮板造型铸造大型纪念鼎工艺简单、成本低廉且效率较高。A method for casting a large commemorative tripod was introduced, that was scraper modeling. The order of scraper modeling has been listed. Actual casting production has been done, and large commemorative tripod made of QT450-10, height of 1960 mm, diameter of 1530 mm has been successfully casted out. The practice shows that using scraper modeling to cast large commemorative tripod is simple process, low cost and high efficiency.

关 键 词：纪念鼎 刮板造型 铸造 

分 类 号：TG242.4[金属学及工艺—铸造]