检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]北京交通大学电子信息工程学院,北京100044
出 处:《计算机技术与发展》2015年第7期27-30,共4页Computer Technology and Development
基 金:国家科技重大专项(2012ZX03005003)
摘 要:随着IPv6无线传感器网络技术的不断发展及其在应用领域的不断扩大,实际部署的网络呈现出大规模、低功耗、有损等网络特点。为此,IETF提出了一种低功耗有损网络路由协议—RPL。然而RPL协议并没有考虑多个汇聚节点间的负载均衡,容易造成部分汇聚节点由于负载过重产生拥塞甚至失效,从而降低网络吞吐量。文中基于RPL路由协议,提出了一种基于多汇聚节点的IPv6无线传感网负载均衡路由协议—LB-RPL。实验结果表明,文中设计的路由协议通过少量的协议额外开销,可以提高大规模网络的整体吞吐量。Nowadays, with the continuous development of IPv6 wireless sensor network technology and its constantly expanding applica- tions, the actual deployed network showing the features of large-scale,low-power and iossy. For this reason, IETF proposed a low-power lossy network routing protocol RPL. However RPL protocol does not consider load balancing among multiple aggregation nodes, which likely to cause partial aggregation nodes congest or even failure due to overload, thus reducing the network throughput. Based on RPL, a load balancing routing protocol of IPv6 multi-sink wireless sensor network called LB-RPL is proposed in this paper. Experimental results show that the proposed routing protocol can improve the overall throughput of large-scale networks by only increasing small amount of protocol overhead.
关 键 词:IPv6无线传感器网络 负载均衡 低功耗有损网络路由协议 多汇聚节点
分 类 号:TP393[自动化与计算机技术—计算机应用技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.199