基于物联网技术的多电机监控系统的设计  

Design of multi-motor monitoring system based on Internet of Things technology

作　　者：丁俊 王茂祥[1,2] 李多贵 王斌[1] 朱金荣 

机构地区：[1]扬州大学,江苏扬州225002 [2]中国移动通信集团江苏有限公司,江苏南京210029 [3]扬州广播电视总台技术传输中心,江苏扬州225009

出　　处：《现代电子技术》2015年第15期136-138,141,共4页Modern Electronics Technique

基　　金：江苏省教育厅高校科研成果产业化推进工程项目(JHB2012-43)

摘　　要：针对目前工业现场对交流电机缺乏有效监控的问题,为实现对交流电机的参数采集和智能监控,设计了基于物联网技术的多电机监控系统。该系统通过传感器测量电机及其所处环境的相关参数,利用无线自组织网络技术将数据传输至以S3C2440为核心的控制中心,采用SimpliciTI协议进行网络通信,并通过GSM模块进行远程数据传输。实验表明,该系统能够准确测量相关参数,及时发现电机的堵转、缺相、三相不平衡等问题,有效保护电机。Since industry field is lack of effective monitoring to AC motor,multi?motor monitoring system based on Internet of Things was designed to realize parameter acquisition and intelligent control for AC motor. In this system,the motor′s relevant parameters and its surrounding environment are measured by the sensor. By using wireless self?organized network technology,data are transmitted to control center,which takes S3C2440 as control core. SimpliciTI protocol is applied to proceeding network com?munication,and remote data transmission is conducted by GSM module. The experimental results show that the system can mea?sure relevant parameters accurately,discover motor′s blocked?rotor,lack of phase and three?phase imbalance problems in time. The motor is protected effectively.

关 键 词：物联网 自组织网络技术 S3C2440 SimpliciTI协议 

分 类 号：TN99-34[电子电信—信号与信息处理]