检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:施鲁莎[1] 邓东升 别学清[3] 王圣萍 徐桂中[1]
机构地区:[1]盐城工学院岩土工程研究所,江苏盐城224005 [2]南水北调东线江苏水源有限责任公司,南京2100029 [3]江苏省工程勘测研究院,江苏扬州225002
出 处:《三峡大学学报(自然科学版)》2015年第4期39-43,共5页Journal of China Three Gorges University:Natural Sciences
基 金:国家自然科学基金青年基金(51408524);江苏省交通厅科技项目(2014T01-1);江苏省"333高层次人才培养工程"科研项目
摘 要:为了解国内颗粒分析方法与国际上通用的方法之间的相关性,分别根据国际通用规范ASTM(D422)和我国的《土工试验方法标准》(GB/T50123-1999)对多种天然土样和纯粘土矿物开展颗粒分析试验,探讨两者之间的异同.试验结果表明:ASTM法获得的粒径分布曲线位于GB/T法上方,两者之间的差异主要发生在粒径为0.005~0.075mm间,并且差异随粒径的减小而增大,随土样的液限的增加而增加.此外,ASTM法与GB/T法对蒙脱土的影响较大,对高岭土的影响较小.最后,分别建立了采用ASTM法与GB/T法获得的粒径小于0.005mm颗粒含量和粒径小于0.002mm颗粒含量相互间转化的方法.In order to identify the difference between particle analysis results achieved by according the International rule ASTM(D422)and Standard for Soil Test Method in China(GB/T50123-1999),this paper analyzes multiple natural soil sample and pure clay mineral particle by above two standards respectively.According to the analysis,the particle distribution curve for ASTM lies above the one according GB/T.In the curve,when particle diameter is from 0.005 to 0.075 millimeter,the difference between two curves is more significant.And the difference keeps growing while diameter getting smaller and this trend also can occur with liquid limit increasing.In addition,the analysis for montmorillonite will be quite different when using these two standards but not for the kaolin sample.At last,the conversion method about particles content finer than 0.005 mm and 0.002 mm obtained by ASTM method and GB/T method are established respectively.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.75