检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:夏俊明[1,2] 孙海龙 霍文青[1] 徐跃民[1] 孙越强[1] 白伟华[1] 柳聪亮[1] 孟祥广[1]
机构地区:[1]中国科学院空间科学与应用研究中心,北京100190 [2]中国科学院大学,北京100190
出 处:《强激光与粒子束》2015年第8期210-215,共6页High Power Laser and Particle Beams
基 金:国家自然科学基金项目(41405039;41405040)
摘 要:利用脉冲磁约束线形空心阴极放电装置,在15mT磁场约束下,产生了持续时间为200μs、峰值放电电流为3A、面积为60cm×60cm的大面积等离子体片。采用快帧法和旋转空心阴极法,在90~210Pa内,利用朗缪尔探针首次获得了不同气压的等离子体片的厚度向电子密度分布及其演化构成的二维分布图;研究了在同等峰值放电电流条件下,等离子体片达到最大厚度向峰值电子密度时,气压对所需放电时间、最大厚度向峰值电子密度及电子密度半高宽的影响。结果表明:在相同的峰值放电电流条件下,等离子体片达到最大厚度向峰值电子密度的时间随气压的降低而减小;气压越低,最大厚度向峰值电子密度越大,电子密度半高宽越小。Large planar plasma sheets with size of 60cm×60cm,maximum current of 3Aand duration of 200μs,were obtained in a pulsed linear hollow cathode discharge device under 15 mT magnetic field confinement.The electron density 2-D distribution in the thickness direction and its evolution of plasma sheets with pressures between 90 Pa to 210 Pa were obtained by Langmuir probe using the fast frame function of oscilloscope and the rotating hollow cathode method.The effects of pressure on the time needed to reach the maximum peak density in the thickness direction,the maximum peak density and the full width at half maximum(FWHM)peak density,were investigated.The results show that,as the pressure decreased,the time reaching the maximum peak density in the thickness direction and the FWHM peak density diminished,while the maximum peak density in the thickness direction increased.These results could be utilized to manipulate the parameters of large planar plasma sheets.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.43