共混工艺对PE-g-MAH增容PA6/LDPE共混物形态和性能的影响  

Influence of Blending Procedures on Morphology and Properties of PA6/LDPE Compatibilized by PE-g-MAH

作　　者：崔同伟 马秀清[1] 

机构地区：[1]北京化工大学机电工程学院,北京100029

出　　处：《塑料工业》2015年第8期33-36,共4页China Plastics Industry

摘　　要：在同向双螺杆挤出机中研究了不同共混工艺对马来酸酐接枝聚乙烯(PE-g-MAH)增容尼龙6(PA6)/低密度聚乙烯(LDPE)共混物形态和性能的影响。采用二步法比一步法制得的共混物中分散相尺寸小,二步法中共混工艺不同所制得共混物的分散相尺寸及其分布也有所不同;共混工艺对拉伸强度和弯曲强度影响较小,对冲击强度影响较大;熔体流动速率随分散相尺寸的增大先升高后降低。Nylon 6 （ PA6）/low-density polythene （LDPE） blends compatibilized by maleic anhydride grafted polyethylene （PE-g-MAH） were studied in a co-rotating twin-screw extruder with different blending procedures. The result showed that the particle sizes of dispersed phase produced by twice melt-blending were smaller than that produced by once melt-blending. The particle sizes and distribution of dispersed phase of blends varied with different blending procedures in the twice melt-blending method. The blending procedure influenced tensile and blend strength weakly, while it influenced impact strength strongly. The melt flow rate of the blends rose firstly and then decreased with the increase of dispersed phase of blends.

关 键 词：共混工艺 聚集态结构 力学性能 熔体流动速率 

分 类 号：O631[理学—高分子化学]