局部热处理对SPCC压印接头静力学性能的影响  

Influence of Local Thermal Treatment on Static Mechanical Behavior of Clinched Joints of Cold Rolling Steel(SPCC)

作　　者：王医锋 何晓聪[1] 曾凯[1] 刘福龙[1] 卢毅[1] 

机构地区：[1]昆明理工大学机电工程学院,云南昆明650500

出　　处：《热加工工艺》2015年第14期217-219,共3页Hot Working Technology

基　　金：国家自然科学基金资助项目(50965009);昆明理工大学分析测试基金项目(20140974)

摘　　要：为研究局部热处理对SPCC冷轧钢压印接头静力学性能的影响分析,构建局部热处理试验平台,采用氧乙炔火焰加热方式将SPCC冷轧钢压印接头进行局部加热至870℃后迅速冷水淬火处理。对热处理前后试件进行拉伸-剪切试验,并横向截取压印接头机械內锁部分,先后对其进行金相试验和显微硬度测试试验。结果表明:淬火处理后的SPCC冷轧钢压印接头失效载荷约为4454.01 N,比未热处理压印接头提高45.39%;SPCC冷轧钢压印接头淬火处理后形成大量板条状马氏体;热处理后压印接头部位材料硬度为799.2 4HV,比未热处理提高77.78%。In order to investigate the influence of local thermal treatment on static mechanical behavior of clinched joints of cold rolling steel（SPCC）, a local thermal treatment experiment platform was built, the clinched joints were adopted local thermal treatment to 870 ℃ by oxyacetylene flame and used cold water quenching treatment. Clinched joints with or without thermal treatment were performed tensile-shear test, and cut out mechanical lock part of the clinched joints along horizontal direction, then successively adopted metallographic and micro-hardness test. The results show that the SPCC clinched joints adopted quenching treatment, the failure load is 4454.01 N and form a large amount of lath martensite, in comparison to the clinched joints without local thermal treatment, its failure load enhances by 45.39%. The hardness of clinched joint materials is 799.24 HV after local thermal treatment, increasing by 77.78%.

关 键 词：局部热处理 压印接头 金相组织 显微硬度 

分 类 号：TG156.3[金属学及工艺—热处理]