用循环极化曲线研究Al和铝合金的点蚀行为  

Characterization of Pitting Behavior of Pure Al and Al-7Zn-0.1Sn-0.015Ga Alloy by Cyclic Polarization Technique

作　　者：贺俊光[1,2] 文九巴[1] 孙乐民[1] 高军伟[1] 

机构地区：[1]河南科技大学材料科学与工程学院,洛阳471023 [2]河南科技大学河南省有色金属共性技术协同创新中心,洛阳471023

出　　处：《腐蚀科学与防护技术》2015年第5期449-453,共5页Corrosion Science and Protection Technology

基　　金：河南省重点攻关项目(132102210119);河南省教育厅重点项目(14A430001);洛阳市科技攻关项目(1301001A)资助

摘　　要：通过循环极化确定纯Al和Al-7Zn-0.1Sn-0.015Ga(质量分数,%)合金在3.5%Na Cl溶液中的自腐蚀电位Ecorr、点蚀电位Epit、点蚀转变电位Eptp和保护电位Erp,并通过Al和铝合金在这些特征电位的点蚀形貌研究了它们的点蚀行为及点蚀扩展机理。结果表明:在点蚀电位时开始出现点蚀坑,随着电位升高点蚀坑迅速向横向和纵向扩展直至保护电位;纯Al的点蚀坑为窄而深的方形点蚀形貌,蚀坑内部为粗糙的结晶状结构,且表面出现明显的丝状腐蚀。Al-7Zn-0.1Sn-0.015Ga合金的点蚀形貌为宽而浅的圆形腐蚀坑,蚀坑内部比较光滑,且丝状腐蚀消失。合金元素能明显活化合金,降低点蚀坑深度,改善其腐蚀形貌。Pitting corrosion behavior of pure Al and Al-7Zn-0.1 Sn-0.015Ga （mass fraction, %） alloy in 3.5%NaCl solution was studied by cyclic polarization technique in terms of characteristics of corrosion potential Ecorr, pitting potential Epit, pitting transition potential Eptp and repassivation potential Erp. While the corrosion morphology of them was investigated by scanning electron microscopy （SEM）. The results showed that pits initiate at the pitting potential, they grow quickly both in depth and diameter with the increasing potential until the protective potential. Pits formed on pure Al are narrow and deep square pits, the inner wall of which exhibits rough crystalline structure with a fila- ment corrosion like surface. While pits on Al-7Zn-0.1Sn-0.015Ga alloy are wide and shallow circular pits, with relatively smooth wall but without the filament corrosion like feature. Alloying elements can significantly activate the alloy, reduce its pitting depth, and thus alter the corrosion morphology.

关 键 词：铝合金 牺牲阳极 循环极化曲线 点蚀行为 

分 类 号：TG174.41[金属学及工艺—金属表面处理]