极限压剪状态下铅芯橡胶支座应力分析  

Stress Analysis of Lead Rubber Bearing under Compress-shear Limit State

作　　者：王建强[1] 辛伟[1] 李政[1] 赵卓[2] 

机构地区：[1]郑州大学土木工程学院,河南郑州450001 [2]宁波工程学院建筑工程学院,浙江宁波315211

出　　处：《建筑科学》2015年第9期83-87,共5页Building Science

基　　金：国家自然科学基金(U1204502);河南省重点科技攻关项目(102102210062)

摘　　要：采用ABAQUS对铅芯橡胶支座进行模拟分析,研究支座在极限压剪状态下的应力分布,分析表明:极限压剪状态下钢片层中的拉应力S11和S22、压应力S33及切应力S12对钢片层Mises等效应力的影响较大;支座有效承压区内大部分钢片层中有部分区域的Mises等效应力超过了其屈服强度,产生了屈服;支座内部各橡胶层的Mises等效应力较小,橡胶未发生破坏。The finite element analysis of the lead rubber bearing is conducted by ABAQUS,the stress distribution of the bearing under compress-shear limit state is studied. The results are as follows： under compress-shear limit state,the tensilestress S11,S22,compressive stress S33 and shearing tress S12 have much effect on the Mises equivalent stress of the steelsheets; the Mises equivalent stress of some areas in the effective confined region of the steel sheets exceeds the yield strength,so the steel sheets yield; the Mises equivalent stress of the rubber sheet is small,the rubber is not damaged.

关 键 词：铅芯橡胶支座 有限元分析 极限压剪状态 应力分析 

分 类 号：TU352.1[建筑科学—结构工程]