检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:徐伟[1,2] 李育珍[1] 段太成[2] 陈杭亭[2]
机构地区:[1]太原理工大学环境科学与工程学院,太原030024 [2]中国科学院长春应用化学研究所电分析化学国家重点实验室,长春130022
出 处:《分析化学》2015年第9期1349-1352,共4页Chinese Journal of Analytical Chemistry
基 金:国家自然科学基金(No.21275138);吉林省科技创新中心(大型科学仪器装备提升)项目(No.20150623001TC)资助~~
摘 要:建立了电感耦合等离子体质谱法(ICP-MS)测定高纯二氧化锡电极材料中Cu,Cr,Mn,Co,Ni,Cd,Fe和Pb等关键性杂质离子的新方法。以2 m L浓HCl为介质,基于高温高压密闭溶样技术,在230℃时保持3 h可将0.1 g样品完全分解。进一步结合氮气吹扫氯化物基体分离技术,实现了150℃挥发温度时和1.5 h时间内单次〉99.9%的基体去除效率,有效消除了后续ICP-MS测定的基体效应以及潜在的质谱干扰。全分析流程加标回收率在100%±5%以内,6次样品平行测定值的相对标准偏差(RSD)在0.09%~3.68%之间,方法检出限(3σ)在0.002~0.034 mg/kg之间,表明本方法不仅具有较好的精确度,而且具有较高的灵敏度,可适用于纯度高达6N的二氧化锡电极材料中杂质离子的检测。应用此法成功测定了3个标称为4N纯度的二氧化锡电极材料实际样品。A new method for determination of trace Cu, Cr, Mn, Co, Ni, Cd, Fe and Pb impurities in high pure tin oxide material was proposed. 0.1 g of sample was successfully digested at 230℃ in 3 h when autoclaves with high pressure and high temperature were used. After that, over 99.9% of the matrix Sn was removed by chloride volatilization at 150℃ for 1.5 h, which eliminated the matrix effect and spectra interference in the following ICP-MS detection. The recoveries for all the analytes of the spiked test were 100% +5%, the RSDs for 6 runs of sample analysis were from 0.09% to 3.68%, and the limits of detection (LOD, 3σ) were from 0. 002 mg/kg to 0. 034 mg/kg, which indicated that the established method were of both accuracy and high sensitivity, and could be applied for the analysis of samples with purity up to 6N. Finally, three samples specified with 4N purity were analyzed by this method.
关 键 词:电感耦合等离子体质谱 氧化锡电极材料 金属杂质 氯化物挥发分离
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:3.133.106.206