正交试验优化脉冲磁场-电沉积Ni-TiN复合镀层工艺研究  

Study on optimization of plating parameters for Ni-TiN composite coatings prepared by pulse magnetic-electrodeposition method

作　　者：马春阳[1] 刘滨瑜 朱永永[2] 夏法锋[1] 李洋[1] 

机构地区：[1]东北石油大学机械科学与工程学院,黑龙江大庆163318 [2]重庆第二师范学院经济与工商管理系,重庆400067

出　　处：《功能材料》2015年第19期19115-19117,共3页Journal of Functional Materials

基　　金：国家自然科学基金资助项目(51474072)

摘　　要：为改善钻井泥浆泵活塞的耐磨性能,采用脉冲磁场-电沉积方法在40Cr试件表面制备Ni-TiN复合镀层。利用磨损试验机、电子分析天平、扫描电镜、正交试验法研究并优化Ni-TiN复合镀层的制备工艺参数。结果表明,当磁场强度为0.5T时,Ni-TiN复合镀层的磨损量到达最小值0.72 mg,当阴极电流密度和占空比分别为2.2A/dm2和50%时,Ni-TiN复合镀层的磨损量达到最小值6.4 mg。脉冲磁场-电沉积Ni-TiN复合镀层的最佳工艺参数为磁场强度0.5T,电流密度2.2A/dm2,占空比40%。In order to improve the wear resistance of pistons in drilling mud pumps,Ni-TiN composite coatings were prepared by pulse magnetic-electrodeposition method on the surface of 40 Cr pistons.The plating parameters for preparing Ni-TiN composite coatings were investigated by using abrasion machine,electronic analytical balance,scanning electron microscope,and orthogonal test.The results show that the Ni-TiN composite coating deposited at magnetic intensity of 0.5Thad the minimal wear mass loss(0.72mg).And the Ni-TiN composite coating prepared at current density of 2.2A/dm2 and on-duty ratio of 50% had the minimal wear mass loss(0.64 mg).The optimized parameters are listed as follows:magnetic intensity 0.5 T,current density2.2A/dm2 and on-duty ratio 50%.

关 键 词：正交试验 Ni-TiN复合镀层 工艺参数 

分 类 号：TQ153[化学工程—电化学工业]