检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李保卫 韩磊[1,2] 李解[1] 王介良[1] 祖刚[1] 杨仲禹
机构地区:[1]内蒙古科技大学内蒙古自治区白云鄂博矿多金属资源综合利用重点实验室,内蒙古包头014010 [2]河北钢铁集团承钢公司提钒钢轧二厂,河北承德067002
出 处:《矿冶工程》2015年第5期99-102,共4页Mining and Metallurgical Engineering
基 金:内蒙古科技厅重大专项;内蒙古自治区高等学校科学研究项目(NJZY13135);白云鄂博矿多金属资源综合利用国家重点实验室资助项目(BO-13-001)
摘 要:针对褐铁矿铁品位难提高的问题,采用“微波还原焙烧-磁选”工艺,将褐铁矿还原成磁铁矿,弱磁选后获得高品位磁铁精矿。采用SEM和XRD检测方法,研究了褐铁矿微波焙烧过程中的矿相演变规律,同时采用单因素实验方法,重点考察了保温时间、焙烧温度、配碳量以及磁选电流和磨矿细度对焙烧矿磁选结果的影响。结果表明:随着温度升高,褐铁矿逐渐还原为磁铁矿,加热到570~650℃时,生成大量磁铁矿,750℃下焙烧矿烧结严重,并产生大量弱磁性的硅酸亚铁,不利于后续磁选。单因素实验结果及分析表明,褐铁矿微波还原焙烧-磁选最佳工艺条件为:保温时间7.5 min,焙烧温度650℃,配碳量1.40%,磁选电流0.6 A,磨矿细度-0.044 mm。最终获得的铁精矿品位、回收率及产率分别为61.33%、75.11%和40.17%,达到了炼铁生产入炉要求。In view of the difficulty in upgrading iron grade of limonite, the technique of reduction roasting-magnetic separation by microwave heating was proposed to make limonite firstly reduced into magnetite, which was subjected to low-intensity magnetic separation, resulting in the high-grade magnetite concentrate. The mineral phase variation during the process of reduction roasting of limonite by microwave heating was investigated by SEM and XRD analysis. And the effects of heat holding time, roasting temperature, carbon content, magnetic current and grinding fineness on the results of magnetic separation were investigated through single-factor test. Results showed that limonite was gradually reduced into magnetite with the rising temperature, and a large amount of magnetite were produced at the temperature ranges of 570-650 ℃. However, serious sintering of roasted ore would be occurred at 750 ℃, resulting in the generation of ferrous silicate with weak magnetism, being unfavorable for the following magnetic separation. The single-factor test results showed that the process of reduction roasting-magnetic separation of limonite by microwave heating, with the optimum condition including heat holding time of 7.5 min, at the temperature of 650℃, carbon content of 1.40%, magnetic current of 0.6 A, and grinding fineness at -0.044 mm, can result in the final iron concentrate grading 61.33%Fe at the recovery of 75.11%, with the yield of 40.17%, which can meet the feed requirement for ironmaking production.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.117