玉米收获机底盘车架疲劳寿命研究  

Study on fatigue life of frame for corn combine chassis machine

作　　者：陈志[1] 周林[2] 赵博[2] 梁学修[2] 

机构地区：[1]中国机械工业集团有限公司,北京100080 [2]中国农业机械化科学研究院土壤-植物-机器系统技术国家重点实验室,北京100083

出　　处：《农业工程学报》2015年第20期19-25,共7页Transactions of the Chinese Society of Agricultural Engineering

基　　金：国家国际科技合作专项项目(2015DFA71560)

摘　　要：提出一种玉米收获机底盘车架疲劳寿命预测方法。利用ANSYS软件对玉米收获机底盘车架进行有限元分析,得到最大模态变形位置和静应力分析条件下的应力分布;在有限元分析数据基础上,粘贴应变片,组建应力测量系统,实测田间及道路条件下的应变时间历程;对采集的应变数据开展预处理,初步分析其受力情况及动载荷特征,采用n Code软件完成疲劳寿命预测。试验结果表明,车身横梁疲劳寿命为24.1万h、支撑部件寿命为16 500万h,满足使用要求,但支撑部件强度设计过剩,采用workbench的shape optimization对该部件开展轻量化设计,在满足疲劳可靠性条件下,减少了该部件质量24%。The chassis frame is the installed base of the corn combine harvester, which bears a lot of force from the longitudinal bending, torsion, lateral bending, horizontal rhombic and their combined loads. The frame has obvious dynamic load characteristics, therefore the static strength check is not enough and research on the fatigue life is needed. As the lack of basic research, the key data accumulation is insufficient, the tradition design method is relatively limited, many Chinese products lack the necessary fatigue strength in design, and the reliability is poor. Experience in the automotive industry has proved that the combination of fatigue load spectrum and CAE technology can greatly improve the forecasting ability. Fatigue strength study of the corn combine harvester is the foundation of improving the reliability and an important method to reduce the structural mass. In order to reduce the structural weight and improve the fatigue reliability of the corn combine harvester, this paper studies a method to evaluate fatigue life of the main frame. Firstly, using ANSYS software, the stress distribution of the corn harvester chassis frame was analyzed, and the stress distribution of the maximum modal deformation position and under static stress analysis was obtained by the finite element analysis. The resonance was the biggest at 81.4 Hz frequency, so S8 point of the maximum strain region was placed on the frame to measure the strain. S5, S9 and S10 points were the high stress concentrated points and strain gauge needed to be placed. Other measuring point was placed on the part redesigned. Secondly, the stress data acquisition system was established, including sensors, data acquisition module and computer. Based on the modal analysis and static analysis, the strain gauge was pasted on the high stress concentrated points with the appropriate method, and the strain time histories of various typical conditions were measured through many experiments, which the operating speed of the corn harvester was the first and seco

关 键 词：疲劳寿命 有限元分析 预测 玉米收获机 底盘车架 轻量化设计 

分 类 号：TH114[机械工程—机械设计及理论] TH123.3