橡胶设备支承框架设计采用SAP2000与PKPM软件计算的分析对比  

COMPARISON OF ANALYSIS RESULTS OF RUBBER EQUIPMENT-HOUSED FRAME USING SAP2000 AND PKPM

作　　者：朱雪峰[1] 

机构地区：[1]中国石化工程建设有限公司,北京100101

出　　处：《石油化工设计》2015年第4期9-11,5,共3页Petrochemical Design

摘　　要：介绍了橡胶设备支承框架的工程概况、结构方案的选择、结构荷载以及所使用的计算软件。由于该框架结构错层较多,分别采用计算软件SAP2000及PKPM对此框架进行结构分析,以验证该结构的设计是否合理;通过比较结构振动周期及内力的计算结果,说明了两种软件的计算值相差不大。选用代表性一榀结构列表分析错层处在恒活载下梁端弯矩及其剪力进行对比,两软件的差别仅为3%左右。由此证明,应用两软件均能较好地完成本结构设计。This article introduces the general engineering situation of rubber equipment-housed frame,the selection of structural scheme,the structural load and the calculating software used.Due to the staggered floor structure,calculation software SAP2000 and PKPM are used to analyze this structural framework to verify the rationality of the structural design.The comparison results of the internal force and the structural vibration cycle show that there is little difference in the calculations of this structure using the two software.The analysis list of a representative and staggered plane frame under the dead load and live load is selected to compare the bending moment and shear force,and the difference is only about 3%.It proves that both of the two software are suitable for the structural design.

关 键 词：橡胶设备支承框架 SAP2000 PKPM 分析对比 

分 类 号：TQ336.5[化学工程—橡胶工业]