检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]南昌航空大学材料科学与工程学院,南昌330063 [2]南昌航空大学科技学院,南昌330034
出 处:《腐蚀与防护》2015年第11期1109-1113,1117,共6页Corrosion & Protection
基 金:铝锂合金化铣工艺研究(省教育厅重点实验室项目)
摘 要:通过正交试验筛选了适合2197铝锂合金化学铣切加工抛光工艺的槽液配方,探讨了材料状态、抛光温度和抛光时间对2197铝锂合金碱腐蚀及化学铣切后表面抛光性能的影响。结果表明,HNO3含量和温度是影响抛光效果的主要因素,CrO3的影响次之,HF最小。材料的不同状态对抛光有较大影响,T8态过时效的铝锂合金抛光后粗糙度最小,T6态欠时效的铝锂合金抛光后粗糙度最大。当抛光的配方和工艺条件为硝酸250g/L、铬酐10g/L、氢氟酸2g/L、抛光时间2~3min、抛光温度25℃时,2197铝锂合金化铣表面能获得良好的抛光效果。The solution formula of polishing process for 2197 Al-Li aluminum alloy was determined by orthogonal experiments, and the major influencing factors of material status, polishing temperature and polishing time were investigated. The results showed that the concentration of HNOa and temperature were the main factors influencing the polishing effect. The second was CrO3, HF had the minimum influence. Different states of materials had great influence on the polishing, T8 state aging of aluminum lithium alloy had the minimum roughness after polishing, T6 state short aging aluminum lithium alloy had the maximum roughness after polishing. Under the conditions of HHOa 250 g/L, CrO3 10 g/L, HF 2 g/L, polishing temperature 25 ℃and polishing time 2--3 min, good performance of surface polishing could be obtained.
关 键 词:抛光 2197铝锂合金 表面粗糙度 光泽度 材料状态
分 类 号:TG178[金属学及工艺—金属表面处理] TG146.2[金属学及工艺—金属学]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.63