检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:郭俊清[1] 陈雄斌[1] 李洪磊[1] 陈弘达[1]
机构地区:[1]中国科学院半导体研究所集成光电子学国家重点联合实验室,北京100083
出 处:《半导体光电》2015年第5期773-776,848,共5页Semiconductor Optoelectronics
基 金:国家"973"计划项目(2013CB329205);国家"863"计划项目(2013AA013602;2013AA013603;2013AA03A104);北京市科技计划项目(Z141100001414004)
摘 要:采用硅光电池阵列作为接收机探测器,在Matlab/Simulink环境中建立了可见光通信(VLC)系统模型,对硅光电池阵列的U-I特性和输出功率特性进行了仿真研究,同时研究了结电容和光照度对硅光电池响应带宽的影响。研究结果表明硅光电池结电容越小,响应带宽越大,硅光电池结电容为2pF时,响应带宽最大可为10MHz,满足无线通信和无线供能复用的可见光通信系统应用要求。In this paper,silicon photocell array was used as the detector for the receiver to establish a visible light communication(VLC)system model in Matlab/Simulink environment.The U-I and output power characteristics of silicon photocell array were studied through simulation,meanwhile,the effects of junction capacitance and illumination value on the response bandwidth were analyzed.The results show that smaller junction capacitance results in greater response bandwidth of silicon photocell.When the junction capacitance is 2pf,the maximum response bandwidth can reach 10 MHz,which can satisfy the application requirements of visible light communication system for wireless communication and wireless energy harvesting simultaneously.
关 键 词:可见光通信 无线供能 光电池探测器 MATLAB/SIMULINK仿真
分 类 号:TN929.11[电子电信—通信与信息系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.170