全自动高速分离及冲模系统设计  

Design of Fully Automatic Separation and Punching Die System

作　　者：李君[1] 

机构地区：[1]东莞理工学院计算机学院,广东东莞523808

出　　处：《实验室研究与探索》2015年第10期55-58,共4页Research and Exploration In Laboratory

基　　金：国家自然科学基金项目(10890095);东莞市科技计划项目(201010814001)

摘　　要：设计了一种全自动高速分离及冲模系统,系统集成型、分离、自动放料和排管设计于一体。分析了多个模块设计的关键技术环节。该系统基于DSP控制,设计了基于DSP控制CCD图像采集及多个模块,介绍了CMOS传感器与DSP接口、触摸屏、PC与DSP通信的实现以及基于可编程控制器控制模块的设计等。结果表明,本系统具有速度高、可靠性高、无故障时间长、误差小、操作方便等优点。A design of fully automatic separation and punching die system was given. The system can place and separate the molding,and automatically feed and exhaust pipe. Key techniques was multiple modules design method which was analyzed. This system was based on DSP control. Image acquisition of CCD based on DSP and many modules were devised. This paper mainly introduced the implementation of the CMOS sensor and DSP interface,the realization of the touch screen,the realization of PC and DSP communication,the design of control module based on PLC and so on.Experiments showed that this system had advantages of high rate,high reliability,long trouble-free,little error and easy operation.

关 键 词：分离及冲模 触摸屏 DSP PLC 

分 类 号：TP274.2[自动化与计算机技术—检测技术与自动化装置] TH715.1[自动化与计算机技术—控制科学与工程]