轧制变形量对Al-5Zn-3Mg-1Cu合金显微组织和力学性能的影响  被引量:2

Effect of Rolling Deformation on Microstructure and Mechanical Properties of Al-5Zn-3Mg-1Cu Alloy

在线阅读下载全文

作  者:李东锋[1] 张新明[1] 刘胜胆[1] 尹邦文 雷越[1] 

机构地区:[1]中南大学材料科学与工程学院,湖南长沙410083

出  处:《华南理工大学学报(自然科学版)》2015年第11期75-80,共6页Journal of South China University of Technology(Natural Science Edition)

基  金:国家重点基础研究计划项目(2012CB619501);国际科技合作专项项目(2013DFG51890)~~

摘  要:采用室温拉伸试验、Kahn撕裂试验,结合光学显微镜、透射电子显微镜等方法,研究了Al-5Zn-3Mg-1Cu铝合金厚板在热轧过程中随轧制变形量增大其合金组织和力学性能的演变过程.结果表明:热轧变形过程中,变形量从56%增大至91%时,合金的再结晶分数由0.49%增大至43.30%,晶粒尺寸从83μm减小至10μm以下,合金的抗拉强度和屈服强度分别从542.3和520.0 MPa提升到593.4和564.9 MPa,延伸率从8.0%左右提高到11.2%;随轧制变形量的增大,合金撕裂强度和单位面积裂纹形核功呈增大的趋势.Tensile test at room temperature and Kahn tear test were conducted to investigate the evolution of the microstructure and mechanical properties of Al-5Zn-3Mg-1Cu thick plate during the hot rolling by means of OM and TEM. The results show that( 1) during the hot rolling of the aluminum alloy,both the deformation and the fraction of recrystallization increase respectively from 56% and 0. 49% to 91% and 43. 30%,while the grain size decreases from 83 μm to below 10 μm;( 2) meanwhile,the tensile strength and yield strength of the aluminum alloy increase respectively from 542. 3 and 520. 0 MPa to 593. 4 and 564. 9 MPa,and the elongation increases from about 8. 0% to11. 2%; and( 3) as the deformation increases,the tear strength( TS) and UIE of the aluminum alloy tend to increase.

关 键 词:铝合金 轧制变形 力学性能 拉伸试验 Kahn撕裂试验 

分 类 号:TG146.2[一般工业技术—材料科学与工程]

 

参考文献:

正在载入数据...

 

二级参考文献:

正在载入数据...

 

耦合文献:

正在载入数据...

 

引证文献:

正在载入数据...

 

二级引证文献:

正在载入数据...

 

同被引文献:

正在载入数据...

 

相关期刊文献:

正在载入数据...

相关的主题
相关的作者对象
相关的机构对象