循环流化床锅炉风室静压分布对床温偏差影响的试验研究  

Experimental Research on the Effect of Static Pressure Distribution in Plenum on the Bed Temperature Deviation of Circulating Fluidized Bed Boiler Boiler

作　　者：宋晓童 侯勇[1] 董伟[1] 徐钢[1] 刘文毅[1] 杨勇平[1] 

机构地区：[1]华北电力大学国家火力发电工程技术研究中心,北京102206

出　　处：《锅炉技术》2016年第1期35-38,共4页Boiler Technology

基　　金：国家自然科学基金(51476053)

摘　　要：某300 MW循环流化床锅炉在运行过程中,中部床温与左右两侧床温偏差达到110℃以上,给运行人员优化调整带来困难。以国内某电厂同型锅炉为案例,设计并实施了水冷风室静压分布的现场试验,并结合试验数据,深入分析了水冷风室静压分布对床温偏差的影响。结果表明:该厂1号锅炉水冷风室静压呈现中间略高,两侧略低的趋势,最大静压和最小静压偏差在风室平均静压的1%以内,总体而言各区域静压偏差较小。因此,水冷风室静压分布不能作为该型锅炉床温偏差的主要影响因素。通过调整水冷风室静压值,即适当加大一次风风量,可以适当的减小床温偏差。A 300 MW CFB boiler occur the problem that the temperature deviation between the middle and the both sides of the bed achieves more than 110℃ during operation, which brings adjustmental difficulty to operators. Based on the experiment data of static pressure distribution in the water-cooled plenum, a deep analysis for the effect of static pressure distribution in plenum on the bed temperature deviation has been carried out. The results show that the static pressure distribution of water-cooled plenum presents an trend of the middle＇s above the both sides＇ , the static pressure deviation was small in general. Thus the main reasons of causing the boiler bed temperature deviation is not the static pressure distribution of water-cooled plenum, the bed temperature deviation could be decreased by adjusting static pressure in the water-cooled plenum.

关 键 词：循环流化床锅炉 静压分布 床温偏差 

分 类 号：TK229.66[动力工程及工程热物理—动力机械及工程]