检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]福州大学电气工程与自动化学院,福州350108 [2]国网福建长乐市供电有限公司,福建长乐350200
出 处:《电气技术》2015年第12期31-35,51,共6页Electrical Engineering
摘 要:在中性点不接地系统中,单相接地故障与铁磁谐振时有发生,二者的外在表现特征非常相似,难以区分。本文分析了单相接地故障与铁磁谐振电压、电流特征,提出了利用HHT频率检测及信号注入相结合的识别方法。HHT频率检测法实现对分频和高频谐振故障的检测,利用H桥型逆变器注入电流信号实现对基频谐振故障的检测,避免了将铁磁谐振故障误判断为单相接地。仿真结果验证该方法能够有效识别谐振状态与单相接地故障。In an isolated neutral point power system, single-phase grounding fault and ferroresonance happen frequently. It is "difficult to distinguish fault types because the external performance of them are similar. This paper analyzes the voltage and current characteristics of single-phase grounding fault and ferroresonance, then put forward the method of signal injection in combination with HHT frequency detection. The method of HHT achieve the distinction between low frequency and high frequency, then using the H bridge inverter to inject current signal to identify fundamental resonance fault, This way avoid the ferroresonance fault judgment error for single-phase grounding.This method is used to identify single-phase grounding fault from ferroresonance, verification by simulation data reveals that the measure is right and effective.
关 键 词:中性点不接地系统 铁磁谐振 单相接地故障 HHT 信号注入
分 类 号:TM862[电气工程—高电压与绝缘技术]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.104