以预处理剩余污泥为燃料MFC产电性能及不连续供电的可行性  

Performance of Electricity Generation and Feasibility of Discontinuous Power Supply of MFC by Using Pretreated Excess Sludge as Fuel

作　　者：赵艳辉[1] 赵阳国[1,2] 郭亮[1,2] 

机构地区：[1]中国海洋大学环境科学与工程学院,青岛266100 [2]中国海洋大学海洋环境与生态教育部重点实验室,青岛266100

出　　处：《环境科学》2016年第3期1156-1162,共7页Environmental Science

基　　金：新世纪优秀人才支持计划项目(NCET-12-0501)

摘　　要：为探讨微生物燃料电池(microbial fuel cell,MFC)处理经预处理后剩余污泥的可行性以及不连续供电能力,采用双室MFC,以剩余污泥热处理上清液为基质进行启动和运行,通过改变电池阴极电子受体而导致电势差变化来监测其产电的运行稳定性.结果表明,反应器以氧气作为阴极电子受体148 h后启动成功,最大输出电压0.24 V,将阴极电子受体换为铁氰化钾时,能获得0.66 V的最大输出电压和4.21 W·m^(-3)的最大功率密度.当将阴极电子受体分别替换为氧气或者开路,又转换为铁氰化钾后,电池输出功率恢复迅速,电池对有机物去除效率基本不受影响,对化学需氧量(COD)、氨氮去除效率分别达70%和80%.本研究表明,利用预处理剩余污泥进行MFC处理和产电是可行的,可获得较高的功率密度,同时MFC可以实现不连续供电.The feasibility of treating pretreated excess sludge and capacity of supplying continuous power of microbial fuel cells（ MFCs） were investigated. Two-chamber microbial fuel cells were started up and operated by using thermal pretreated excess sludge as the substrate. Potential fluctuations were achieved by changing the cathode electron acceptor. During the changes of electron acceptor,the operational stability of MFCs was assessed. The results indicated that the MFCs started successfully with oxygen as the cathode electron acceptor and reached 0. 24 V after 148 hours. When the cathode electron acceptor was replaced by potassium ferricyanide,MFCs could obtain the maximum output voltage and maximum power density of 0. 66 V and 4. 21 W·m^（-3）,respectively. When the cathode electron acceptor was changed from oxygen to potassium ferricyanide or the MFCs were closed circuit,the output power of MFCs recovered rapidly. In addition,changes of electron acceptor showed no effect on the removal of COD and ammonia nitrogen.Their removal efficiencies approached to 70% and 80%,respectively. This study concluded that MFC could treat the pretreated excess sludge and produce electricity simultaneously with a high power density. The MFC could also achieve discontinuous electricity supply during operation.

关 键 词：微生物燃料电池 剩余污泥 电子受体 不连续供电 功率密度 

分 类 号：X382[环境科学与工程—环境工程] X703