检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:崔传智[1] 盛倩 姜亦栋[2] 杨峰[2] 贾培锋
机构地区:[1]中国石油大学(华东)石油工程学院,山东青岛266580 [2]中国石化胜利油田分公司东辛采油厂,山东东营257094
出 处:《石油钻探技术》2016年第1期79-84,共6页Petroleum Drilling Techniques
基 金:国家科技重大专项"断块油田特高含水期提高水驱采收率技术"(编号:2011ZX05011-003)资助
摘 要:稠油在井筒举升过程中,由于热损失造成温度下降,致使其黏度迅速增大,举升负荷较大。因此,研究稠油举升中的井筒保温对策具有现实意义。基于传热学的基本原理,采用计算稠油井井筒温度场的Hansan模型,以东辛油田Y12X2X3井为例对井筒温度分布进行了计算分析,并对影响稠油井井筒温度的油管类型、油管长度和产液量等3项参数进行了优化,提出了采用长度1 000m的D级隔热油管和普通油管组合、产液量由11m3/d提高到20m3/d的井筒保温措施。现场试验显示,井口温度由调整前的20.5℃升高至41.5℃,井深1 000m以浅井段原油黏度大幅度降低,原油流动性增强,有杆泵充满程度增加,泵效提高了47%。研究结果表明,采用稠油井筒温度场计算模型能准确描述井筒温度的分布情况,并能有针对性地制订稠油井井筒保温措施。Due to thermal loss and temperature drop during oil lifting in the wellbore,the viscosities of heavy oil may increase rapidly and so will the lifting loads.Accordingly,it is important to develop effective insulation techniques for borehole to enhance productivity of heavy oil.The Hansan mathematical model for calculating the heavy oil wellbore temperature was established based on the theories of thermal transmission.The wellbore temperature distribution in Well Y12X2X3 was calculated and analyzed.In addition,the liquid-producing capacity,the type and length of insulation tubing were analyzed and optimized as main factors of wellbore temperature distribution.Reasonable wellbore heat preservation measures included choosing insulated tubing which length with a length of 1,000 mand increasing the fluid volume from11m3/d to 20m3/d.Field application showed that the wellbore temperature was enhanced from 20.5℃to41.5 ℃,and the viscosity of crude oil above a depth of 1,000 m was greatly reduced.Eventually,the fluidity of oil as well as the filling level of the rod pump were also increased while the pumping efficiency increased by 47%.The results showed that the mathematical model for calculating the heavy oil wellbore temperature could describe the wellbore temperature accurately and the resulting effective wellbore insulation measures could be followed to enhance heavy oil productivity.
关 键 词:稠油 热损失 井眼 温度分布 保温油管 采液量 东辛油田
分 类 号:TE345[石油与天然气工程—油气田开发工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.7