硅改性M2高速钢的退火工艺优化  

Optimization Research of Annealing Process for Silicone Modified M2 High Speed Steel

作　　者：王红霞[1] 赵辉[1] 

机构地区：[1]郑州职业技术学院,河南郑州450121

出　　处：《钢铁钒钛》2016年第1期127-130,136,共5页Iron Steel Vanadium Titanium

基　　金：河南省教育厅自然科学研究计划资助项目(2011C430001)

摘　　要：采用不同的退火温度和退火时间对M2-1.0Si硅改性M2高速钢进行退火处理,并通过显微组织、高温力学性能的测试与分析。研究发现:退火温度和退火时间均对硅改性M2高速钢的组织和力学性能产生重要影响,退火温度不宜过高、退火时间不宜过长,保持8 h退火时间不变,随退火温度从760℃增至880℃,M2-1.0Si硅改性M2高速钢的平均晶粒尺寸先基本不变后迅速增大,抗拉强度和断面收缩率均先增加后减小;保持850℃退火温度不变,随退火时间从4 h延长至12 h,硅改性M2高速钢的平均晶粒尺寸先缓慢增大后急剧增大,抗拉强度和断面收缩率均先基本不变后急剧减小。M2-1.0Si硅改性M2高速钢的退火温度优选为850℃、退火时间优选为8 h。Different annealing temperature and annealing time were adopted for annealing treatment of M2-1. 0Si silicone modified M2 high speed steel. Through the test and analysis of the microstructure and high temperature mechanical properties,it is found that the annealing temperature and annealing time had important influence on the microstructure and mechanical properties of silicone modified M2 high speed steel. Too high annealing temperature and too long annealing time were not suitable. When at a given annealing time of 8hours,with the increase of annealing temperature from 760 ℃ to 760 ℃,the average grain size of M2-1. 0Si silicone modified M2 high speed steel firstly remained basically unchanged and then increased dramatically. Both the tensile strength and percentage reduction of area first increased then decreased. When at a given annealing temperature of 850 ℃,with the extension of annealing time from 4 h to 12 h,the average grain size of silicone modified M2 high speed steel increased sharply after slowly increased,tensile strength and percentage reduction of area decreased sharply after basically remained unchanged. Optimum annealing temperature of M2-1. 0Si silicone modified M2 high speed steel is 850 ℃,the annealing time is 8 h.

关 键 词：硅改性M2高速钢 退火工艺 退火温度 退火时间 高温力学性能 

分 类 号：TG161[金属学及工艺—热处理] TG142.1[金属学及工艺—金属学]