检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:杨勇[1] 黄向东[1,2] 赵克刚[1] 李罡 魏建军
机构地区:[1]华南理工大学广东省汽车工程重点试验室,广东广州510640 [2]广州汽车集团股份有限公司汽车工程研究院,广东广州510640
出 处:《湖南大学学报(自然科学版)》2016年第4期44-51,共8页Journal of Hunan University:Natural Sciences
基 金:国家高技术研究发展计划('863'计划)资助项目(2011AAVV11A218);浙江省自然科学基金资助项目(LQ13E070003)
摘 要:运用牛顿力学方法分阶段建立变速器的动力学模型,运用显式动力有限元方法获得单向离合器接合产生的冲击激励.将单向离合器接合产生的激励和传动系输入扭矩的激励叠加,计算了变速器输出端的扭矩、转速响应,并与实测值进行对比.试验结果显示,计算值与实测值吻合较好,说明本文提出的动态接合特性仿真方法对于可控式单向离合器的新型变速器换挡特性研究具有良好的分析效果,相关测试及计算方法对由单向离合器与齿轮副形成的传动系统的设计具有参考价值.This paper discussed the nonlinear torque of the engagement of selectable one-way clutch,which causes shift impact in the transmission.Firstly,dynamic models including steady states and transient state were built on the basis of the second Newton's law.Secondly,the nonlinear torque of the engagement of the one-way clutch was calculated by explicit FEM method.Thirdly,the torque of the output shaft and rotational velocities of both the input and the output shaft were calculated under the excitation of the torque of the input shaft and impact generated by the quick engagement of the one-way clutch,which was obtained by explicit FEM method.Finally,tests on the engagement of the one-way clutch during shifts were carried out.The test results have shown that the torque peaks and the vibration frequencies on the output shaft are similar in different situations when the speed of input shaft is different.The simulation results are similar to the test results.This proves the method proposed is appropriate in the research of the dynamic characters of the transmission shifting by one-way clutches.
关 键 词:变速器 单向离合器 换挡冲击 显式有限元 试验分析
分 类 号:TH132.41[机械工程—机械制造及自动化]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.36