生物促生剂强化处理印染废水的中试研究  

Pilot scale research on the bio-energizer for the strengthened treatment of printing and dyeing wastewater

作　　者：王慧荣[1,2,3] 李明智[1,2,3] 张宇[1,2,3] 梅荣武[1,2,3] 韦彦斐[1,2,3] 任旭峰[1,2,3] 张敏东[1,2,3] 张刚[1,2,3] 李欲如[1,2,3] 

机构地区：[1]浙江省环境保护科学设计研究院工程技术研究中心,浙江杭州310007 [2]浙江省环境污染控制技术研究重点实验室,浙江杭州310007 [3]浙江环科环境研究院有限公司,浙江杭州310007

出　　处：《工业水处理》2016年第5期40-43,共4页Industrial Water Treatment

基　　金：浙江省属科研院所扶持专项条件建设(2015F10009)

摘　　要：采用A/O工艺和接触氧化法,投加生物促生剂强化处理印染废水。研究了投加促生剂前后COD、氨氮、微生物数量、污水中成分的变化。结果表明投加0.10%促生剂,COD基本维持在100-200 mg/L,去除率提高到85%左右,氨氮稳定在10-15 mg/L,去除率提高到75%-80%,微生物数量维持在4.5×10^8-4.8×10^8 CFU/mL。当促生剂的投加量增加到0.15%时,出水COD基本保持在100 mg/L以下,去除率在90%左右,载体上微生物数量维持在5.2×108CFU/mL。出水中主要物质有2种,邻苯二甲酸二异丁酯仍然是主要残留物质,但浓度比投加前降低了很多。Adopting A/O techniques and contact oxidation method,the strengthened treatment of printing and dyeing wastewater has been conducted by adding bio-energizer. The changes of COD,ammonia nitrogen,microorganism quantity and the wastewater ingredients before and after adding bio-energizer have been studied. The results show that,After adding 0.10% of bio-energizer,the effluent COD maintains at 100-200 mg/L,the removing rate is increased to 85% or so;ammonia nitrogen stays at 10-15 mg/L,the removing rate is increased to 75%-80%;and the microorganism quantity maintains at 4.5 ×10^8-4.8 ×10^8CFU/m L. When the bio-energizer dosage is increased to0.15%,the effluent COD is basically maintains at 100 mg/L,the removing rate is about 90%,and the microorganism quantity on the carrier is about 5.2×108CFU/m L. There are only two kinds of substances in the effluent. Diisobutyl Phthalate is still the main residual substance,but its concentration has been reduced a lot,compared with what it was before adding bio-energizer.

关 键 词：印染废水 生物促生剂 强化处理 

分 类 号：X703.1[环境科学与工程—环境工程]