检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:潘俊艳[1] 陈华辉[1] 马峰[1] 谢波[2] 吴迎飞 赵赋[1] 张祚炜[1]
机构地区:[1]中国矿业大学(北京)机电与信息工程学院材料科学与工程系,北京100083 [2]山东兖州煤业股份有限公司综机管理中心,兖州272100
出 处:《中国腐蚀与防护学报》2016年第3期253-259,共7页Journal of Chinese Society For Corrosion and Protection
基 金:兖州综采设备项目(U03320)资助
摘 要:对27Si Mn,30Cr Mn Si,30Cr Mn Ti,40Cr低合金钢以及Q550等5种液压支架常用钢在高矿化度矿井水中的腐蚀性能进行了研究,并以自来水、Na Cl溶液作为对比腐蚀介质进行比较。通过理论计算、盐雾实验、浸泡实验以及电化学实验进行了一系列腐蚀性能测试,同时利用SEM,EDS和XRD等分析手段对成分和形貌进行了分析。结果表明:Cr和Si对低合金钢的耐蚀性有较大影响:在Cl-环境下,Si的作用较大,Cr次之;在O2(水、大气)环境下,Cr的作用较大,Si次之。因此,在矿井水环境下,30Cr Mn Ti和40Cr低合金钢具有较好的耐蚀性。低合金钢在矿井水下的腐蚀,不仅与合金元素有关,还与矿物离子形成的垢膜致密性有关。水垢一方面填充了铁锈腐蚀产物疏松多孔的结构,减缓了低合金钢的腐蚀速率;另一方面,垢下区域由于电解质溶液中氧浓度较低,又加快了腐蚀速率。在3种不同腐蚀介质中,低合金钢的腐蚀程度从大到小依次为:3.5%Na Cl溶液>高矿化度矿井水>自来水。The corrosion behavior of low alloy steels, such as 27SiMn, 30CrMnSi, 30CrMnTi, 40Cr and Q550 was studied comparatively in high-mineralized coal mine water, tap water and Na Cl solution by means of immersion test, salt spray test and electrochemical methods as well as XRD and SEM with EDS. The results showed that elements Cr and Si can significantly affect the corrosion resistance of low alloy steels: in chloride containing media, Si exhibits stronger effect than Cr on the corrosion; whereas in the presence of oxygen(water and gas phase), Cr exhibits stronger effect than Si. Therefore, 30 Cr Mn Ti and 40 Cr have better corrosion resistance in the coal mine water.The corrosion behavior of the low alloy steels in the coal mine water depend not only on the role of alloying elements but also on the compactness of the formed limescale induced by mineral ions.The limescale, on one hand, can fill the porous rust layer, which slows down the corrosion rate of the steel, however, on the other hand, due to the low concentration of oxygen at the zone below the limescale, where the corrosion of the steel can be accelerated. Finally the corrosivity of three corrosive media can be ranked as the order from severe to mild: 3.5% Na Cl solution, high mineralized mine water and tap water.
分 类 号:TG178[金属学及工艺—金属表面处理]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.28