聚丙烯酰胺/海藻酸钙双网络复合纤维的制备及性能研究  

Preparation and properties of polyacrylamide/calcium alginate double network composite fiber

作　　者：张鸿[1] 徐海涛[1] 焦玉龙[1] 祝国富[1] 邢阳阳[1] 于跃[1] 郭静[1] 

机构地区：[1]大连工业大学纺织与材料工程学院,辽宁大连116034

出　　处：《合成纤维工业》2016年第4期38-41,共4页China Synthetic Fiber Industry

基　　金：大连市科技计划项目(2015E11SF050)

摘　　要：以丙烯酰胺(AM)为网络单体,N,N'-亚甲基双丙烯酰胺(BIS)为交联剂,过硫酸铵(APS)为引发剂,采用自由基聚合的方法合成聚丙烯酰胺;以海藻酸钠(SA)为基体,引入聚丙烯酰胺共价交联网络,配制成纺丝原液,用氯化钙作为凝固浴,用湿法纺丝法制备聚丙烯酰胺/海藻酸钙双网络结构复合纤维,并通过正交实验确定最佳工艺参数。结果表明:当SA水溶液的SA质量分数为2%、AM(相对SA)的质量分数为15%、BIS(相对SA与AM总质量)的质量分数为16%、反应温度为60℃、反应时间为1 h,双网络改性海藻酸钙纤维的断裂强度最大达2.628 c N/dtex,增幅达75%;双网络改性海藻酸钙纤维表面的规整程度和光滑程度有所提高,纤维截面孔洞变得细密。Polyacrylamide was synthesized by using acrylamide （ AM） as a network monomer , N,N′-methylenebisacrylamide （ BIS） as a crosslinking agent , ammonium persulfate （ APS） as an initiator by free radical polymerization .Polyacrylamide cova-lent crosslinking network was introduced into calcium alginate （ SA） matrix to prepare a spinning solution which was spun into polyacrylamide/calcium alginate double network composite fiber by wet spinning process .The process parameters were optimized by orthogonal experiment .The results showed that the polyacrylamide/calcium alginate double network composite fiber could be obtained with the breaking strength increasing by 75%up to 2.628 cN/dtex as the process conditions were as followed：2%SA aqueous solution , 15%AM based on SA and 16%BIS based on the total mass of SA and AM by mass fraction , reaction tempera-ture 60 ℃and time 1 h;and the surface regularity and smoothness of polyacrylamide /calcium alginate double network composite fiber were increased in some degree and fine holes appeared in fiber cross section .

关 键 词：海藻酸钠 聚丙烯酰胺 海藻酸钙纤维 双网络纤维 力学性能 

分 类 号：TQ342.94[化学工程—化纤工业]