检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:李闯民[1] 李诗琦[1] 肖玲[1] 闫华文[1]
机构地区:[1]长沙理工大学交通运输工程学院,湖南长沙410114
出 处:《公路交通科技》2016年第11期1-7,共7页Journal of Highway and Transportation Research and Development
基 金:交通运输部公路工程行业标准规范制修订计划项目(2013-23);江西省宜春市科技研究计划项目(20160001)
摘 要:基于我国T0304—2005粗集料试验方法中存在的问题,通过运用Plackett-Burman设计法,针对可能影响粗集料密度及吸水率实测值的试验因子,采用两种不同吸水率水平的(大于2%和小于2%)粗集料,分别研究了粗集料粒径、水分状况、待测样品冷却时间、浸泡时间、擦干状况、水浴温度及测试试样冷却时间等7个因子对粗集料密度及吸水率的影响。统计学方差分析表明,在不同吸水率水平下,这7个因子对粗集料的毛体积密度、表干密度、表观密度及吸水率的实测值有不同程度的影响。在此基础上对我国T0304—2005粗集料密度及吸水率试验方法提出了相应建议。To cope with the problems of method of testing coarse aggregates specified in T0304—2005 , by using Plackett-Burman design method, aiming at the experimental factors which may have effect on the measured values of density and water absorption of coarse aggregates, applying to aggregates with 2 levels of water absorption ( less than 2% or greater than 2%) , the influence of the factors include coarse aggregates size, moisture condition, cooling time of the sample before test, soak time, drying condition, water temperature, and cooling time of the tested sample on density and water absorption of coarse aggregates are studied respectively. Statistical analysis of variance shows that these factors have different degrees of impact on the measured values of bulk volume density, skin drying density, apparent density and water absorption of coarse aggregates. On this basis, the suggest for revising the method for testing density and water absorption of coarse aggregates specified in T0304—2005 is put forward.
关 键 词:道路工程 粗集料密度和吸水率试验 Plackett-Burman设计法 影响因子 方差分析
分 类 号:U416.03[交通运输工程—道路与铁道工程]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.200