检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
机构地区:[1]重庆邮电大学移动通信技术重庆市重点实验室,重庆400065
出 处:《电讯技术》2016年第11期1229-1234,共6页Telecommunication Engineering
基 金:国家自然科学基金资助项目(61301126);重庆市基础与前沿研究计划项目(cstc2013jcyjA 40032);重庆邮电大学博士启动基金项目(A2012-33);重庆邮电大学青年科学研究项目(A2013-31)~~
摘 要:在长期演进(LTE)系统中,发送天线端口数通过循环冗余校验掩码的方式隐含于物理广播信道(PBCH)中,终端在解读PBCH信道获取主信息块(MIB)的同时,需要正确检测PBCH采用的发送天线端口数。传统的检测方法尝试分别用1、2、4等3种发射天线数进行PBCH译码,直至正确译码为止,译码复杂度非常高。基于此,提出一种改进的天线端口数估计算法,提取各天线端口传输的小区参考信号序列做相关,通过相关值与相关系数门限值的比较直接快速获取基站的实际天线端口数。仿真结果表明:该算法相较于传统检测算法和功率检测算法在时间复杂度上分别提升了4个数量级和3倍;在信噪比高于0 d B时,所提检测算法较功率检测算法有4-6 d B的增益。In the long term evolution ( LTE) system,the number of antenna ports is implied in physical broadcast channel ( PBCH) by cyclic redundancy check mask ( CRC mask). When the terminal obtains master information block(MIB),it also needs to correctly detect the number of transmit antenna ports that PBCH uses. But original detection method tries to decode PBCH respectively with 1,2 or 4 antennas u n til decoding correctly,which has high complexity. So an improved algorithm for antenna port number detection is proposed which extracts the cell reference signal ( CRS) in different antenna ports to perform correlation calculation and then get the actual antenna port number of base station by comparing the correlation value with the relevant threshold. Simulation results show that this method,on the time complexity,raises four orders of magnitude and three times respectively compared with the traditional detection algorithm and the power detection algorithm,and has 4 -6 dB gain when compared with the power detection algorithm at 0 dB signal-to-noise ratio(SNR) above.
关 键 词:LTE系统 天线端口数检测 物理广播信道 参考信号
分 类 号:TN911.23[电子电信—通信与信息系统]
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:18.191.91.228