利用光栅提高红外非制冷热探测器效率的研究  

Absorption efficiency improvement of uncooled infrared sensor by using grating

作　　者：吴元庆[1] 张金晶[1] 刘春梅[1] 陆晓东[1] 周涛[1] 

机构地区：[1]渤海大学新能源学院,辽宁锦州121013

出　　处：《电子元件与材料》2016年第12期40-44,共5页Electronic Components And Materials

基　　金：国家自然科学基金资助项目(No.11304020)

摘　　要：非制冷探测器的制备,最常用的方法是通过微机械加工在CMOS读出电路上制作悬桥来实现。传感器将吸收的热量转化为电压信号或电流信号变化由检测电路检出,但该结构吸收效率偏低。本研究提出了一种基于表面等离子体谐振吸收的红外探测器结构。分析了光栅及器件结构参数对红外光学吸收的影响,采用COMSOL软件仿真,研究了金属-介质-金属三明治结构红外探测器的吸收效率,并通过结构参数的优化使吸收结构对特定红外波段的吸收率达到98%以上,在整个波长范围内平均吸收效率达30.5%。When heated by incoming IR radiation, an uncooled infrared sensor changes the temperature variation into a voltage or a current signal, which is detected by the readout circuit. Uncooled infrared sensors are usually made by building cantilevers on CMOS circuits. However, their performance is limited by the low absorption efficiency. To improve the absorption efficiency of an uncooled infrared sensor, the surface-plasmon-resonance structure was proposed. By COMSOL, the variation of the infrared absorption efficient with the structure parameters was simulated and analyzed. An absorption efficient of 98% within a specified spectral band and 30.5% averaged absorption efficiency within the whole wavelength range are reached by parameter optimization.

关 键 词：非致冷 红外 探测器 等离子体谐振 光栅 结构优化 

分 类 号：TN215[电子电信—物理电子学]