基于VC的陀螺定向导线平差软件的设计与实现  

The Design and Application of the Adjustment Calculation Software for the Gyroscopic Orientation Traverse Based on VC

作　　者：刘芳诚 杜宁[1] 王莉[1] 张显云[1] 龙新[1] 裴书玉 

机构地区：[1]贵州大学矿业学院

出　　处：《矿山测量》2016年第6期64-67,共4页Mine Surveying

基　　金：贵州省科技厅联合资助项目(黔科合LH字[2014]7646);贵州大学研究生重点课程建设项目(贵大研ZDKC[2015]029);贵州大学测绘科学与技术研究生创新实践基地建设项目(贵大研CXJD[2014]002〗);贵州大学矿业学院研究生创新基金(院研20160121)

摘　　要：随着矿井向深部及边界开采,井下基本控制导线的长度在不断增加,误差也随之增大。加测陀螺定向边能有效控制测角误差累积,提高精度,以满足矿山生产、特别是大型巷道贯通的要求。为了满足生产的实际需求,以给定的判定条件为依据,将陀螺定向边分为坚强边与非坚强边,采用附有限制条件的间接平差模型,在VC的编译环境下开发的陀螺定向导线(坚强边、非坚强边)平差计算软件,通用性强,计算成果严密、准确、客观。With the mining expanding to the deep part and the boundary, the length of the underground basic controltraverse is increasing, which also leads to the rise of the error rate, but the additional gyroscopic orientation edge caneffectively control the accumulation of angle measurement errors and improve accuracy, which meet the requirementsof the mine production, especially of the large laneway holing. This thesis classifies the gyroscopic orientation edgeinto the strong side and the non - strong side in accordance with the given conditions and according to the indirectadjustment model with constraints the adjustment calculation software for the gyroscopic orientation traverse （thestrong side and the non - strong side） is developed in the VC compiling environment, which is equipped with thevalue of wide universality and rigorous, accurate and objective calculated results.

关 键 词：坚强边 非坚强边 坐标方位角限制条件 间接平差 VC 

分 类 号：TD178[矿业工程—矿山地质测量]