采用功率坐标变换的微网并联逆变器控制方法  

Control Method for Parallel Inverters in Microgrid Based on Power Coordinate Transformation

作　　者：程军照[1] 王文玺[1] 陈江波[2] 

机构地区：[1]云南电网有限责任公司电网规划研究中心,云南省昆明市650011 [2]中国电力科学研究院(武汉),湖北省武汉市430074

出　　处：《电力系统自动化》2017年第1期117-121,共5页Automation of Electric Power Systems

基　　金：国家自然科学基金资助项目(51307154)~~

摘　　要：下垂控制是微网中逆变器并联运行的常用控制方法,但有功功率—频率(Pf)下垂会导致稳态频率偏差,减小下垂系数虽可减小频率偏差但会影响控制性能。针对上述问题,将虚拟阻抗、下垂控制和功率坐标变换相结合提出新的控制方法,利用虚拟阻抗对有功功率P和无功功率Q进行坐标变换,得到广义有功功率Pd和广义无功功率Qd,并证明Pd和f存在下垂关系,Qd可通过虚拟阻抗的大小进行调节。然后,根据负荷功率因数选择虚拟电阻和虚拟电抗的比值,使Pd在稳态时趋于零,从而使稳态频率偏差趋于零,再按照逆变器额定容量的反比选择下垂系数及虚拟阻抗大小从而实现P和Q的按比例分配。所提方法可以使稳态频率偏差趋于零,并能实现有功和无功负荷的按比例分担,MATLAB仿真证明了所述方法的有效性。Droop control is widely used in parallel operation of inverters in microgrid. This control method will lead to frequency deviation. Although frequency deviation can be reduced by decreasing the droop coefficient, the control performance will be affected. This paper proposes a new control method by combining the droop control, virtual impedance and power coordinate transformation. Coordinate transformation is carried out for the active power P and reactive power Q by virtual il＇apedance, by which general active Pd and general reactive power Qd are obtained. Droop characteristic between Pd and frequency f is proved while controlling Qd by adjusting the virtual impedance. By choosing the ratio between virtual resistance and virtual reactance according to the power factor of load, Pd will approach zero and thus the steady-state frequency deviation will be made to approach zero. The P and Q sharing is adjusted by choosing proper droop coefficients and the impedance amplitude inversely in inverse proportion to inverters＇ rated capacity. The proposed method can achieve near zero steady state frequency deviation and proportional sharing of active power and reactive power. Simulation by MATLAB has confirmed the effectiveness of the proposed control method.

关 键 词：下垂控制 微网(微电网) 并联逆变器 功率坐标变换 频率偏差 

分 类 号：TM464[电气工程—电器]