X62W型铣床电气线路故障模拟装置的研制  

Development of X62W Type Milling Machine Electric Circuit Fault Simulation Device

作　　者：牟少芳 于春风[2] 丁新平[1] 余岱玲 宋英杰[1] 

机构地区：[1]青岛理工大学自动化工程学院,山东青岛266520 [2]海军航空工程学院青岛校区,山东青岛266041

出　　处：《中国仪器仪表》2017年第2期69-72,共4页China Instrumentation

摘　　要：针对X62W型铣床的电气线路故障模拟设备存在线路复杂、故障率高、安全性低、灵活性差等不足,以继电—接触器控制、模拟开关、低压信号指示灯基本环节为主,全面分析了X62W型铣床电气控制原理、常见故障及调试过程。在此基础上研制一种电气控制状态和工作台进给方向直观判断的新型故障模拟装置。According to the Hebei Energy Institute of electrical circuit X62W universal milling machine fault simulation equipment has complex circuit, high failure rate, poor reliability and disadvantages of poor flexibility etc. Based on relay contactor control, analog switch and low voltage signal indicator, The electrical control principle, common faults and debugging process of X62W milling machine are analyzed. On the basis of this, a new type of fault simulation device is developed, which can be used to judge the state of electrical control and the feed direction of the working table.

关 键 词：电气控制 闪光继电器 X62W万能铣床 进给方向 

分 类 号：TG54[金属学及工艺—金属切削加工及机床]