检索规则说明:AND代表“并且”;OR代表“或者”;NOT代表“不包含”;(注意必须大写,运算符两边需空一格)
检 索 范 例 :范例一: (K=图书馆学 OR K=情报学) AND A=范并思 范例二:J=计算机应用与软件 AND (U=C++ OR U=Basic) NOT M=Visual
作 者:张帆[1,2] 唐永生[1] 刘造保[1,3] 邵建富[1,3] 盛谦[2] 周辉[2] ZHANG Fan TANG Yongshenga LIU Zaobao SHAO Jianfu SHENG Qian ZHOU Hui(Sino-French Joint Research Center of Rock and Soil Mechanics and Concrete Materials, Hubei University of Technology, Wuhan Hubei 430071, China State Key Laboratory of Geomechanics and Geotechnical Engineering, Institute of Rock and Soil Mechanics, Chinese Academy of Sciences, Wuhan , Hubei 430071, China Laboratory of Mechanics of Lille, University of Lille, Villeneuve arAscq 59650, France)
机构地区:[1]湖北工业大学岩土力学与混凝土材料中法联合研究中心,湖北武汉430071 [2]中国科学院武汉岩土力学研究所岩土力学和工程国家重点实验室,湖北武汉430071 [3]法国里尔科技大学里尔力学实验室,法国里尔59650
出 处:《岩石力学与工程学报》2017年第3期644-649,共6页Chinese Journal of Rock Mechanics and Engineering
基 金:国家自然科学基金资助项目(51579093;51479193);国家重点基础发展计划(973)项目(2015CB057905)~~
摘 要:黏土岩具有低渗性和自我裂缝修复能力等优点,被用于高放废物地质处置的候选基岩。出于高放废物处置库的长期性及高安全性要求,研究黏土岩的蠕变破坏特征显得极其重要。通过一系列黏土岩的单级三轴压缩蠕变试验,获得Callovo-Oxfordian(COx)黏土岩较为精确的蠕变速率阈值范围。试验结果表明,发生蠕变破坏的蠕变速率阈值与黏土岩的湿度及所处围压等因素有关。总体上,当轴向蠕变速率低于2.5με/h,该类黏土岩很难发生蠕变破坏;但若高于58με/h,则黏土岩极易发生加速蠕变破坏;而处于两者之间的速率值,目前试验尚无明确结论。该阈值可用于在稳定蠕变阶段判断黏土岩是否会出现加速蠕变破坏。Clay rocks have the advantages of low permeability and crack self-sealing ability and are thus chosen as a potential geological barrier for underground disposal of radioactive waste in France and other countries. The high security and long-term requirements of underground radioactive waste disposal require that it is necessary to investigate the time-dependent behaviors of clay rocks. This paper presents the results of a series of one-step creep tests for the purpose of identifying with a relative high precision the creep rate thresholds of the Callovo-Oxfordian argillite with different moistures under the triaxial creep conditions. Three moisture levels are investigated in this paper for complete creep tests. The results show that the creep rate threshold values are related to the moisture and confining pressure. Generally, if the axial creep rate is smaller than 2.5 με/h, the tertiary creep does not occur. Otherwise, if the axial creep rate is greater than 58 με/h, the tertiary creep is likely to happen. Although the values between the two thresholds are still questionable, the thresholds are helpful to know in advance whether the tertiary creep would happen.
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在载入数据...
正在链接到云南高校图书馆文献保障联盟下载...
云南高校图书馆联盟文献共享服务平台 版权所有©
您的IP:216.73.216.30