一高线3号飞剪控制系统的优化  

Optimization of No.3 Flying Shear Control System in No.1 High-speed Wire and Rod Line

作　　者：赵国良 宇喜福 ZHAO Guoliang YU Xifu(Bar and Section Plan)

机构地区：[1]棒线型厂

出　　处：《柳钢科技》2017年第2期37-39,共3页

摘　　要：柳钢第一高速线材生产线3号飞剪改造完成后存在剪切长度不稳定,剪头和剪尾有不剪、多剪等现象,严重制约了生产的稳定和产量提高,介绍在信号传输、信号隔离、控制系统等方面实施的优化与改进措施以及效果。After transforming No.3 Flying Shear of No. 1 High-speed Wire and Rod Line in Liuzhou Steel, the shearing length was not stable, the front end and back end were not cut or cut too much which seriously ham- pers the production stability and the output increase. The optimization and improvement measures and results in respects of the signal transmission, signal isolation, control systems and others were introduced.

关 键 词：高速线材生产线 飞剪 控制系统 信号传输 信号隔离 

分 类 号：TG333.62[金属学及工艺—金属压力加工]